1999 isuzu rodeo with 2.2 4 cyl sat for 2-3 months in freezing temps and wont start now. The battery is charged, the fuel pump is working fine and the fuel rail has pressure. I changed the plugs and wires and checked that they all get spark when the starter cranks. it still wont start. Has anyone had this problem? If so please help me figure out what Im missing. Thank you.

SOURCE: 1999 Yukon cold start problems.

1999 Yukon Start Issue - I have replaced the octopuse, battery, fuel filter, fuel pump, still having problems starting in cold weather, sometimes after a heavy rain.

Any suggestions?

Thanks

SOURCE: 1995 AUDI 90 CS - Hard to start... spark & fuel OK

Have you tried replacing the starter? I know starters can go bad if the car is not started or run for a long time.

I am getting the same car, with the same issue.. it sat for 2 yrs and won't start.

My mechanic told me it is probably a starter.

Troy Kirby

• 15 Answers
• Posted on May 24, 2009

SOURCE: wont start

well if it dies after 15 20 min, then ide check your alternator cause that's what recharges the battery. just pull it out bring it to checker or auto zone or advanced wherever you go and they can tell you if it bad or not

SOURCE: 2001 jeep cherokee sport 6 cyl 4 wdr cranks want start

If the data link is not talking to the computer check your ground at the computer and at the data link connector to see if the computer is even alive ground pin 3 on DLC with the key off then turn key to the run position if it flashes the check engine codes record them, if no engine light, does the engine light come on when you turn the key on then go off? if not, check fuses if not check power for pin on computer, if it has power you have a bad computer. But TEST THE GROUNDS IT IS THE BIGGEST FAILURE For these rigs or any manufacture. check that you have power also at the DLC too. if not you need a digital ohm meter and a subscription to http:///.www.alldatadiy.com and start reading the campaigns on that vechile for computer and trouble tree for dead DLC and computer. I don't have that subscription or I could tell you more where to look, if you need anymore help let me know. Also if the crank sensor could cause it not to run the fuel pump but so can the cam sensor. You need to find out if the computer gets it's pulse for the pump at the computer if it does then you need to test them both. There are three wires a ground a colored power wire and a wire to go to the computer you can test these sensors with a meter to see if there is a pulse to each. sometimes the fuel pump gets it's signal from the coil pack so it's important to have the subscription, you can do a search for each item and test them as needed and has a wiring diagram.

SOURCE: 95 isuzu rodeo whont start

look at the starter wheel for missing teeth