96 subaru no power to the master window switch

Video on youtube How To Install Replace Master Power Window Switch Subaru Outback 00 04... This still a Subaru !

I have had the control switches them selves leak

fuse or motor in the door pannel

motor is probably shot for window or window switch on the door check power to the switch and whether it sends power out but if your gettin noise when you push it it may be the regulator

Your problem is likely in the master switch on the driver side. Try getting a drivers door switch from the junkyard. I have a 96 Silhouette that I experienced the same problem with. After changing out the motor, and the passenger switch I finally traced it to the master switch. Power goes to the drivers door switch first and then over to the passenger door. It could actually be both switches. A bad relay would affect both windows not just the one side.

so you mean no power any where it does not run?you might have made bad connection at battery.

You just did. Its the master switch. Buy a switch from a large parts store, use a flat tip screwdriver to remove switch then install new switch. This should take you about 20 mins. Super Easy

check and see if window lock feature is on,the switch is on the master switch,sounds silly but the easy this can sometimes get overlooked

Hi there,
Very simple. Only one of a few things. First off. Push the up and down switch, listen, if there is a humming sound, your actuator may be fine. You window may be off track. If it is not off track, and there is a humming sound, then it may be the master switch. They are not that expensive. If it is not the master switch, the only other two things it could be is the up/down button or the connectors under the button. I hope that helped you out. Good luck and let me know. Have a great day.~MWD