Oil was changed but light stays on
Right on the instrument cluster glass there should be the odometer button and a rectangular slot if there is a slot slid your key into it, don't worry if your key doesn't go all the way in its not supposed to.
If you need further help, reach me via phone at https://www.6ya.com/expert/joe_a79eed575e8dd8b3
SOURCE: maitneance required light
Hi.. after you do this step come back and rate as fixya. OK..
Turn the ignitio key to run position
Push and hold for 5 seconds the Trip reset botom.
With the botom pushed turn the ignition key to OFF position.
Keeping pushed the botom.
Turn the Ignition switch to RUN position. keep pushed the trip botom for 10 seconds or untill you see the MAINT_Requi. go OFF.
Remember all this steps with the trip botom pushed. OK.
I hope this solve your question. Thank you for use fixya.
SOURCE: Maintenance required light is on. 1996 Honda Accord
Simple way to check if anything goes wrong is to go to Autozone store (if you are in US) and scan for trouble codes (if there are any of them). They do it free of charge. If you get any codes you can get the explanation of them here
http://www.troublecodes.net/honda/
Good Luck
SOURCE: Maintenance light is blinking for a while in 2005 honda accord
To reset your light do the following:
1-Push maintence reminder button in and hold it in. (thats the button near the speedo on the insturment cluster)
2-Turn the ignition to the on position while holding button in.
3-Wait several seconds until the light goes out, then let go of the button.
It is now reset
Now this is the maintaince light and not the check engine light correct? If then just follow above and do that.
Also if you don't use Fram oil filters you can go 5000miles on your oil and be safe. Even honda says you can do 7000miles but 5000 gives you a buffer if you need to go over.
SOURCE: How reset service interval light (already changed oil, oil filter, etc)
the service interval "light " has nothing to do with emissions or a problem with the car . There is a rectangle slot on the dash cluster you just use your key and press it and it just resets the counter
SOURCE: reset maintenance light
If I remember correctly, on the dash you have a select button. Hold the button down then turn the key on, until the maintenance light blinks and goes out. Turn the key off then back on and your light should be out.
210 views
Usually answered in minutes!
×