I need to replace the rocker cover gasket on my 1997 Hyundai Accent GLS (engine code G4EH, 1.3L). Can anyone kindly provide me with torque specs for re-tightening the rocker cover? Thanks!
SOURCE: torque specs.for hyundai accent? need to torque
step 1 26 ft lbs.
step 2 additional 90 degrees
step 3 loosen all bolts one full turn
step 4 26 ft lbs.
step 5 additional 90 degrees
SOURCE: i have a 1997 hyundai elantra 1.8 i need torque specs. for head
go to http://www.hmaservice.com/ and register. After that, you'll have access to manuals, service bulletins, wiring diagrams, etc.
SOURCE: need torque specs for connecting rod and main
Torque in two to three stages.
Connecting rods are 24-26 lb.ft.
Main bearing caps are 41-44 lb.ft.
Hope this helps,Chuck
Testimonial: "Thanks for the help Chuck"
SOURCE: good morning changing haed gasket
cylinder head bolts 52-55 ft lbs. engine cold 59-63 ft lbs. engine hot
rocker arm shaft bolts 15-20 ft lbs.
intake manifold bolts 11-15 ft lbs.
exhaust manifold bolts 22-30 ft lbs.
valve cover bolts 79-81 in lbs.
SOURCE: I need the torque pressure
Fig. 12: Cylinder head bolt loosen and tighten sequence - 1.5L (VIN
K), 1.6L (VIN R), 2.0L (VIN F) and 1996-98 1.8L (VIN M) engines
2.0L (VIN F) and 1996-98 1.8L (VIN M) engines-Tighten M10 bolts to
22 ft. lbs. (30 Nm), plus 60°-65°, plus 60°-65°. Tighten M12 bolts to
26 ft. lbs. (35 Nm), plus 60°-65°, plus 60°-65°.
1.5L (VIN E), 1.5L (VIN J) and 1.5L (VIN K) engines-51-54 ft. lbs. (71-75 Nm).
1.6L (VIN F), 2.0L (VIN P) and 1994-95 1.8L (VIN M) engines-65-72 ft. lbs. (90-100 Nm).
Hope helps.
1,884 views
Usually answered in minutes!
×