Cars & Trucks Logo

Related Topics:

P
Piotr Kowalski Posted on Feb 27, 2014

Cruse control don't respond in toyota avensis 2007. After change sat nav unit the cruse is not responding the dash board light is ok. When I remove the sat nav the cruise is ok and is working.

  • Piotr Kowalski
    Piotr Kowalski Feb 27, 2014

    Yes it is I think so. I have bought that one but is the same AISIN and even looks the same.

×

5 Related Answers

Anonymous

  • 6966 Answers
  • Posted on Aug 04, 2008

SOURCE: 98 chevy k1500 cruse control

Hi,

Appreciate the "Ask Me".

To my knowledge, Cruise Control would be relatively difficult to diagnose without a scan tool attached to the control module to read the error codes. Additionally, car versions in my country seldom have such a device since our roads are narrower and travel distance is not that great.

Though most known causes are:

  • the connector to the module;
  • loose brake pedal/switch;
  • loose clutch pedal/switch (for manual transmission);
  • vacuum line to actuator (most likely), vacuum actuator, diaphragm, control valve.
Other possible components to check are:
  • the control module itself (bolted to the firewall);
  • control cable or linkage;
  • speedometer sensor;
  • steering wheel controls switches;
  • throttle position sensor.
As posted above, quite a number of possibilities. Any other indications, speedometer OK; abnormal throttle responses; abnormal idling, brake light always ON, slack in the accelerator/gas pedal? Was it cutting in/out before? Was there any recent repair work done on the engine before the cruise control cut out?

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Ad

Anonymous

  • 4 Answers
  • Posted on Aug 10, 2008

SOURCE: cruse controll

I thought that my cruise control was not working also. But, I just wasn't setting it up right.

Try this:
1.Press the cruise control button make sure the light is green.

2.Accelerate to the speed that you want to cruise on.

3.Once you are at the speed you want to go, select the Set Accelerator button on the steering wheel. Your cruise control should work, if not I'm not sure what the problem could be.

GOOD LUCK!

Anonymous

  • 962 Answers
  • Posted on Nov 02, 2008

SOURCE: cruse control not working

Check the air control hoses for the cruise control.

Anonymous

  • 1 Answer
  • Posted on Apr 21, 2009

SOURCE: auto has 23K and cruse stopped working. checked

I had the same problem with my 2003 santa fe. Do you have any brake lights out in back? Weird as it is, as soon as I fixed a burned out brake bulb, my cruise worked again. The only relation I can think of is that tapping the breaks causes cruise to turn off - so maybe a broken brake/tail light passes a singal to cruise control from some reason???

Jordan Waldrop

  • 147 Answers
  • Posted on Aug 15, 2009

SOURCE: cruisecontrol on vw touareg doesn't turn on or indicate on dash

computer might be bad and a bit pricy. there should be a secound throttel cable make sure their both attatched

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 06 Mitsubishi galant and the cruse control lights up on the dash but it will not set the cruse could u tell me what it might be

It has it's own module. It doesn't turn on any lights though. But it can be scanned for codes or problems.
0helpful
1answer

2007 Honda civic which fuse control the cruse control

The fuse diagram is on the back of the fuse panel cover. If not, or is lost, open the owner/operators manual. You'll find the diagram there.
0helpful
1answer

2001 impreza Abs light on and cruise control not working

From what I have read the flashing cruse light is to get you to fix the problem. Any cel will throw the cruse light and cruse will not work. Get your abs checked out and cruse will work again when fixed.
2helpful
1answer

My 2007 Toyota Avensis 1.8 benzin does not charge the battery, what could be fault?

Check the obvious, the drive belt, if thats ok, start engine and turn on headlamps, rev engine and see if the lights brighten,if not, the quick diagnosis would point to the generator, Regards Mike
0helpful
1answer

Trip computer,cruse,turn signals and right side of digital dash not working

well the cruse control has a cruse control module check that out but for the the turn signals and dash light if you already replaced the fuse maybe the lights burned out or you have a bad ground somewhere
0helpful
1answer

Turn cruse on light on dash shows to be on but will not set speed ?

There is a switch that links the brakes to the cruse control unit it works off the brake light switch . You see the crouse control needs to know when the brake is applyed so if you hit traffic it will shut it off . This is likely your problem look under the dashboard it will be close to the brake switch on the top of your pedal and have a wire connecting to that switch
0helpful
1answer

Cruise controll

I guess the cruse is'nt working? You first need to look it over to see if everythings hooked up. Did it work for you before or you haven't seen it work? The switch on the dash will light after turning it on but the car has to be running for it to turn on . Does the light light? if not check the fuses and see if thier any blown? To check to see that everything is hooked up find the throttle body, one cablr goes to the gas pedal and the other goes to the cruse, follow this cable to the cruse unit and see if that unit has all it's wires and hoses connected. To check you remove them and reconnect them looking into the plug or hose for dirt rust bent pins. The hoses can crack on the inside and leak which will make it not engage. Follow these hoses to where thier connected to the engine and the brake pedal as they can split and be disconnected there too. The brake pedal switch has to work too as does the clutch switch ( if it has a clutch) If the brake lights don't work niether will the cruse. The hi mount brake light if the bulbs fail the cruse won't work. The switch on the steering wheel can get disconnected too as it's on a clockspring circuit as the steering wheel has to turn. Is the airbag light on? if it is and the horn does'nt work either it's likly that the clockspring is broken, If the horn works and the airbag light cycles like it's suposed to then the clockspring is likly OK. The speedometer has to work too as the speed senser that works it also works the cruse.If everything is working your problem could be more seriuos but it's not likly as this unit is quite reliable.
0helpful
1answer

What is the miliage for the timing belt, spark - 11190 miles

Toyota ,says 170 ,for the timing belt, plug's every 50,000,or once a year ,along with a fuel filter,and air twice a year depending on road condition's,oil changes about every three month's or about, 3,000 miles .
remove the alarm ,and repair the splices.
Not finding what you are looking for?

242 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...