Went you press to turn up heater it turn it self off
SOURCE: Heated seats won't stay on in 2004 GMC Yukon Denali
See GM TSB 05-08-143-001, If you have Adjustable pedals, especially if they don't work with the memeory buttons, but function with thier own buttons. Its the Brake Pedal Position Sensor is shorted and mesing up the seat module which controls the heaters too. My 05 Suburban had the same issue
SOURCE: 2004 yukon xl denali self-leveling rear air shocks
There's a lever that connects the driver-side rear shock to the Automatic Level Control module (the air compressor and the ride-height sensor). Disconnect the lever from the shock and rotate it up and hold it. The compressor should kick in when you hold in place after a few seconds. If it doesn't kick in, make sure your fuses and relays are good. Otherwise, you may have a failed ALC module/burned out air compressor (from the shocks being shot). After you replace the shocks (and after you recouped from the heart attack you had when you shelled out $500+ for each shock), replace the ALC module/compressor (it's all one unit), and test it - it should kick on when you rotate the lever up again.
Figure about $350 for the ALC module from your dealer, and make sure the part numbers match! Your truck came with an upgraded ALC module from the 2001-2004 module, which were prone to water damage.
Good luck!
SOURCE: Heated Seats, Yukon Denali
You will need to replace the switch module, it is the only thing that can cause this to happen
182 views
Usually answered in minutes!
×