Hi my abs vdc and slip light came on and won't go off. I have a nissan maxima 2010
These same lights were coming on in my Nissan. I read that the alarm had something to do with the switch monitoring the break pedal. I found that there are two switches monitoring my pedal. The switches can be adjusted in and out by turning the switch about 30 degrees, slide the switch in or out, then turn it back. One switch causes the break lights to come on and the other does not do anything obvious. I found that if I bounced the break pedal quickly I could cause the alarm to activate. I adjusted the switches until the one that does nothing obvious changes states before the one that turns on the break lights. I tested the break pedal and was unable to cause the alarm.
I think a trip to the nissan dealer may be needed. The Slip and VDC sytem is tied into the anti-lock brake system. Could be as simple as a vacuum leak or a bad check valve at the brake booster, or the ABS system could be malfunctioning.
OBD2Guide com Technical service for OBD2 auto scan tools
SOURCE: ABS, VDC Off, SLIP light all ON
need to read codes for abs system as a fault in abs can cause other codes propbably not a diy job
SOURCE: 2000 NISSAN MAXIMA TRANSMISSION SLIPPING
If you havent already try to change the transmission filter.Sometimes when the filter gets dirty fluid pressure is comprimised and certain pumps and solenoids which control shifting inside the transmission function off of the fluid pressure,
SOURCE: 2005 Pathfinder - all warning lights on
was toll before disconnect the battery for five seconds and it will clear all the lights codes
1,115 views
Usually answered in minutes!
×