Turn signals chattered for a bit then quit completely. Is ita separate relay for hazard and turn signals? Hazards work and I can find that relay by the sound and feel. Do both circuits run through the same relay? If so I could replace the one relay I've found and not continue looking for an additional one.
The FSM book covers this.
as does alldata.com, (USA cars)
checked fuses yet?
turn/back fuse.
feeds the.:
turnback relay & answer back relay (module)
a digital switch in the lever (combo) it just sends ground logic
level to the module.
so sound to me to be
one light is shorted. (or trailer wire hacks) "visual inspections!,"
or the module is bad.
if both sides are bad, seems bad module to me,
if all lights blink fully bright on hazard the lights should be good.
the module is just under the steering wheel , under those
plastic covers, the books shows simple access. to the combo
my book dont show module location
i use a rubber hose to my ear to find any relay, clicks.
if you find hazard click , (assuming it does) then same place
is the turn sigs.
its not in the fuse box, cab , i looked.
hope that helps.
alldata.com
has it.
SOURCE: where is the flasher for the turn signals in a 1999 ford explorer
The 2 fuses are no 10 (7.5amp) and no 21(15amp) in the interior fuse panel.The flasher is located on the base of steering column under dash. See this this pic find connector c214 on bottom 3rd from right.
http://i253.photobucket.com/albums/hh43/chuck943/EXN15113.gif
SOURCE: where is the turn signal\hazard flasher located?
it's in the auxiliary relay box behind the glove box.
13350 is base part number on flasher
Testimonial: "Actually found it located behind the radio mounted on a brace. Removed cover and relay pulls out. About 1" cube with 5 terminals on it."
SOURCE: turn signals hazards flasher don't work jeep
I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING
SOURCE: Where is the turn signal relay, hazard relay, and
It is not the flasher if the hazards work, it is 1 flasher for both turn signals and the hazard lamps. It is in a relay block ( along with the blower motor relay ) under the dash, about in line with the steering wheel column ).
Try tilting the steering wheel all the way up, and test again.
The other quick test is to cycle the hazard switch a few times, to see if it cleans the contacts for the turn signal on the MFS,
SOURCE: 1995 Pontiac Grand Am, turn signals do not work.
Bad connection or ground
Testimonial: "If the bulbs work when the hazard switch is activated, where would the bad connection be?"
1,044 views
Usually answered in minutes!
×