Location of Purge Control Valve on 2003 Hyundai Tiburon GT

"Car won't go in reverse" - New Tiburon Forum : Hyundai Tiburon ...

www.newtiburon.com/forums/.../189049-car-won-t-go-reverse.html

Aug 8, 2010 - 23 posts - ‎16 authors
Okay guys I just sold my 03 tiburon GT 6 speed to a 16 year old. I just got a ... Join Date: Sep 2006. Location: ... "It stalls and just drift forward, no reverse lights" Now did he break somethng or is he putting it in 6th..... Any Ideas. ... To view links or images in signatures your post count must be 5 or greater. Location of reverse light switch? - New Tiburon Forum ...
8 posts
Jul 23, 2014
So who's reverse lights don't work? - New Tiburon ...
25 posts
Apr 11, 2009
More results from www.newtiburon.com
Missing: hatchback

2003 Hyundai Tiburon Manual Transmission Complaints

www.aboutautomobile.com/.../Hyundai/Tiburon/Manual+Transmission

My 2003 hyundai tiburon clutch and flywheel broke on 3 separate occasions since ...into reverse, I had a hard time finding it, it would not let me put it into reverse and I ....2006; Description of the Complaint: I have 2003 v6 tiburon, clutch failed at ... bought 2004 5 speed tiburon (she bought it before my problems started) and ...

Transmission Won't Shift/CEL Due to Failed Speed Sensors ...

repairpal.com > Problems > Hyundai > Sonata

The code is an evaporative emission vent valve soleniod malfunction.

Call around to your local auto wrecker/salvage yards, and check ebay before you go to a Hyundai dealer.

WHICH ENGINE?.. 2.0 four cylinder? OR 2.7 V6?
Anyway, sensor 2 is always 'downstream', so it's lower than all the others. V6? lowest near the firewall.. .4 cylinder?.. lowest near the radiator.

Correct, it's near the firewall.

The correct "Hyundai" term for the valve that's attached to the Vapor Canister is the "Canister Control Valve".Why don't you try to clean the old one first. They get clogged with little bits of charcoal from the canister. It's simple so see if it's bad, take it off, and try to blow through the canister side with no electric going through. You shouldn't be able to blow because the valve is supposed to be closed. If you can blow it's because the valve is clogged and hanging open. If it is clogged, you might try and clean it.

Then take the hose off from the canister and clean the hose too, you'll get a handful of charcoal out before your done. If you don't clean the hose out, you'll probably clog the valve again, even if it's new.

That's why they usually change the canister and the valve at the same time. It gets clogged because you fill the tank to the max, it floods the canister with gas, and the charcoal floats up through the hose to the valve.

On your Tiburon the purge valve is located below the throttle body. It is easier to access if you remove the boot between the airbox and the throttle body. After removing the boot look under the throttle body, the purge valve will be found mounted in a rubber hangar and it has a vacuum hose to both ends.

There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:


And the 2.7 Liter V6:

hey
try to use quaker state synthetic bleed multi vehicle atf