My car just shut off and wont start i sprayed starter fluid in fuel injector still just turns over
SOURCE: 2002 oldsmobile alero Security lock no fuel gets to engine
Hi, I just read somewhere on the WWW that the crank sensor and or fuse can be a issue. I too have a 2002 Alero.. Worst car I have ever owned!
SOURCE: wont start
Where the car runs on starter cleaner, this is definitely a fuel problem...
Could be a few things:
Do you hear the fuel pump running outside the car (for a few seconds) when you turn the key on (engine off)?
If not it might be the pump or the pump relay (in the engine compartment fuse and relay box)
If so, it might be:
Clogged inline fuel filter (in the fuel line from the pump to the engine)
Bad fuel pressure regulator
Bad injectors/wiring
Did you check the fuse and wires to see if you have power (and a good ground) to your engine computer (controls fuel injectors), this could also be the culprit (without power to the computer there is no way for the engine to get fuel).
SOURCE: NO SPARK AT PLUGS
Its probably the electrical part under the ignition coils follow your spark plug wires to the back of your firewall and remove both ignition coils and there is an small electrical plate that needs to be replaced and you should get your vehicle running because I had the same problem
SOURCE: 02 alero w/3.4 no start
Have you had any codes pulled?
A cold start issue may be related to a coolant sensor problem. When the engine is cold the engine control module will enrich the fuel mixture for start based on the reading it receives from the coolant sensor.
You can have it checked when cold and the temperature reading should match the out door temp. A scan tool will be required. Or replace the sensor, I believe the cost is less than $20.
Good luck, let me know.
Regards.
SOURCE: car wont start has power has fuel and starter
The security system is activated. It kills the injector pulse ( signal) and on some modles the starter. You will need to try to relearn the system. First try to start the car, leave the key in the run position for 10 minutes. Cycle the key off, then cycle it to the run position again for 10 more minutes. Cycle it off again, then back to run for another 10 min. after the last cycle turn it off then try to start the car. It is a 30 minute relearn. If this does not work you will need a repair shop to replace the passlock sensor. Good Luck
Testimonial: "it was in the ignition and the security activated i had to replace the whole igintion key and all "
195 views
Usually answered in minutes!
×