SOURCE: 2003 Honda Accord Check Engine / Maintenaice Requeried
If you brought your car to Honda for service, they probably forgot to reset the maintenance reminder. If you took it to another shop, they probably did not know how to reset it. Anyway, the reset procedure is:
Put your key in the ignition
Turn the key to the II position for a couple of seconds
Then turn the key to the off position
Now push and hold in the odometer reset button
While still holding the odometer reset button, turn the key back to the II position
Hold for I think 10 seconds or so and your maintenance reminder light should reset it self.
SOURCE: '91 honda accord battery light on with new battery.
either your alternator has gone or your fan belt is not there which helps the alternator to charge the battery get a volt meter on your alternator to see if it is kicking out what it should be
SOURCE: 92 Honda Accord Flashing Oil Light
Are you positive it is the oil light .. If it is then it could be an issue with your oil pump...
SOURCE: The maintenance light blinks on and off 10 times
Maintenance is needed depending on the mileage, anything from an oil change to a major service. then the light can be reset.
SOURCE: D4 blinking, spedometer not working, check engine light on
Hi, a few questions 1st. Did your mechanic check for engine codes? Is your Honda a v-6 or 4 cylinder?
The flashing D4 light indicates a possible transmission malfunction. You should avoid rapid acceleration until the cause of the light blinking is determined.
If you have the V-6, there is a diagnostic port to connect a scan tool to read any stored engine codes that have turned on the check engine light. This port is located behind the ashtray in the center console (most cars did not have this til 96).
If you have the 4 cyl engine, there is a service connector located under the dash on the pass. side. Inside the connector is what looks like a 2 wire plug should be attached. Take a paper clip, unbend it, and insert the 2 ends of the clip into the connector to 'jump' it. Turn the ignition switch to the on position (don't start the vehicle), and the check engine light will flash. Count the flashes, short flashes are for code #'s 1 to 9 (single digit code), a 2 digit code will be a long flash for the 1st digit, followed by a short flash for the 2nd digit. If there is more than one code, they will be separated by a pause. They will repeat so you can count them and write them down. Let me know what the code #'s are so I can help further. Curt
142 views
Usually answered in minutes!
×