SOURCE: chev avalanche 2004 inner tie rods
I was able to fix the inner tie rod problem with a little of patients and 90 bucks for the parts. When I took it in for the front end to be aligned the drivers side was only off by 1/4 on an inch.
SOURCE: what torque spec for chev aveo 2004 cylinder head
18 lb ft+60°+60°+60°+10°
NEW HEAD BOLTS ARE REQUIRED WHEN REPLACING THE HEAD OR HEAD GASKET.
SOURCE: 2005 malibu maxx ball joint and lower control arm torque specs
A Ball Joint Can Usually Be Replaced Without Removing The Control Arm From The Vehicle. Place The Vehicle On Jack Stands. Remove The Shock Absorber And Install A Spring Compressor on The Coil Spring.Remove The Nut Securing The Ball Joint To The steering Knuckle And Separate The Knuckle And Then Joint. The Ball Joint Should Be Pressed,Riveted,Bolted,Or Screwed Into The Control Arm.A Service Manual Will Give The Details For The Specific Make And Model Vehicle.
374 views
Usually answered in minutes!
×