How do you replace harmonic balancer on 99 ford taurus 24v 3.0

SOURCE: HARMONIC BALANCER

I have a '94 Tempo, it had a "ticking" sound. It was the "harmonic balancer" (crankshaft pulley) a local mechanic changed it for $60, the part cost me $120 (I work for a Ford dealership) $180 without employee discount. you can get one for much less at a junkyard if you can find one. Good luck, Sean

SOURCE: 99 ford taurus is running hot. No water leaks,

OHV engine. I have seen these wear the blades off the waterpump. Does the heat work.

SOURCE: replacing the harmonic balancer in ford bronco

First remove radiator fan shrould.This will give you access to the fan.Remove fan and fan belts.Remove bolt on harmonic balancer.You will need to rent a balancer remover and installer kit.Most big auto parts chains will rent these kits to you.Next remove four bolts holding pulley to balancer.Next attach balancer puller to balancer with long bolts from kit.Using a 1\2 drive breaker bar,remove balancer from engine.After removing balancer replace front seal.Lubricate hub on new balancer with engine oil.Then use installation tool from kit to install balancer.Never try to beat balancer on with hammer,engine damage could occur.Then work in reverse to replace remaining parts.Hope this will help you.

SOURCE: 1998 ford Taurus 24v DOHC Overheating not thermostat

check to see if eans coming on if they dont then its fan relay if they are the rad is pluged or ther is an air pocket in the cooling system there should be a bleeder on it

SOURCE: 1999 Ford Taurus 3.0L V6 24V DOHC Duratec Engine

i would check the plug wires and the coils you check the plug wires for bad spots at night start the motor up and look at the plugs if you see a spark arch out the wire and to a peace of metal then the plug wires need to be replace.