Question about 1997 Lexus ES 300
Dealer said that someone replaced the battery cable and that caused the problem. Once I get it started it runs great. The lexus dealer tech said the starter and solenoid is good. But when I try to start it, nothing, just click. If I keep trying, turn key to start click no start, turn off key. try it again, it starts. confusing? some mornings it takes up to 5 minutes to start, turning on the key nothing, turn off the key. Wait a few minutes, try it again, nothing.
Posted by Anonymous on
If the clicking is coming from the starter motor then its the solenoid going, there is a pin that engages the starter to the flywheel, over time the pin wears out and does not engage, causing the clicking sound.
Posted on Jun 12, 2017
Try cleaning and tightening well the battery connections along with the battery wires to the solenoid and starter motor.
Bad connections and low voltage of 12 volts can result in this anomaly.
Posted on Jun 12, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If your is exhibiting the same signs as a dead battery it really sounds like your alternator is bad. If you are handy, you can remove the alternator and take it to an autoparts store like autozone and they will test it for you. This is not a hard job to do, usually 2 electrical connections, 3-5 mounting bolts and you have to pop the belt off. Just reverse it to install a new one. Good luck! - Nick
Posted on Nov 03, 2008
You may have corrosion inside your battery cables or a loose connection somewhere.
If you have a voltmeter connect one lead to the POSITIVE post of the battery and the other to the POSITIVE post on your starter while you have a friend crank the engine
WATCH YOUR HANDS!
This is called a voltage drop test and you should see less than 0.5v on the multimeter while you are trying to start it, if you have high resistance (corrosion bad connections) you will see a higher voltage. 0.5v is the MAX you should see.
Do the same test on the ground side of the circuit, connect to the NEGATIVE battery terminal and the starter case, your voltage reading should be 0.1v or less
Posted on Feb 24, 2009
There are a number of things that could cause that. Try turning the key to the on position and crossing the starter terminals with a screwdriver. If it starts you have a bad ignition. If it still just clicks your starter has seized up or your battery might be lacking the charge to do the job. Hope these help you.
Posted on Jun 28, 2009
Tips for a great answer:
Dec 29, 2016 | Jeep Cars & Trucks
Sep 17, 2014 | Cars & Trucks
Feb 10, 2012 | 2009 Ford Escape
Jun 15, 2011 | 2005 Chevrolet Impala
Aug 13, 2010 | Nissan Altima Cars & Trucks
May 05, 2009 | Saturn SL2 Cars & Trucks
Apr 17, 2009 | 1995 Jeep Grand Cherokee
Feb 22, 2009 | 1987 Ford F 150
Jun 25, 2008 | 1990 Volkswagen Cabriolet
57 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: