Replace lower oil pan 2006 kia sportage v6 ex

SOURCE: 2001 kia sportage blower motor resister

Rule of thumb...unless you get a better answer:  look for a couple of wires on a small plate that is in the airflow of the fan on the heater/ac unit.  The resistor pack is always air cooled by the fan.

SOURCE: 2000 kia sportage ex, 4 cyl.

Yes there is a sensor that controls Fuel/air ratio.It's called a MAF (mass air flow sensor)
But I think you should have the EGR (Exhaust gas recirculation)valve checked
and The TPS (throttle position sensor)maybe dirty.

Although may things can cause this issue,I would look at the items above first.


Please rate this a blue fixya

Mike Butler

• 6674 Answers
• Posted on Mar 01, 2009

SOURCE: 2006 sportage timing belt- how to change

Here you go, just ignore part about removing sprockets. Click on pictures for larger view.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801bca65

ZJ Limited

• 17989 Answers
• Posted on Jan 12, 2010

SOURCE: how to remove oil pan on kia sportage 99?

Hi Zak:
Kia Sportage 1998-02 Repair Guide
Oil Pan - Removal & Installation

1. Before servicing the vehicle, refer to the precautions at the beginning of this section.
2. Drain the engine oil.
3. Remove or disconnect the following:
   
   Negative battery cable 2 Top intake manifold bracket bolts Front 3 axle housing mounting bolts, 4WD only Left front bushing from the axle housing mount and lower the front axle housing Both gusset plates from the engine Transmission under cover Engine under cover Oil pan mounting bolts and using a scrapper tool separate the oil pan Oil pan Oil strainer assembly Oil baffle
   


Fig. Exploded view of the oil pan assembly mounting

1. Clean the engine block, oil pan and baffle pan surfaces of any gasket material.
2. Apply a continuous bead of Loctite Ultra Blue 587® silicone sealant around the baffle pan.
3. Install or connect the following:
   
   Oil baffle. Torque the bolt to 84 inch lbs. (9.5 Nm). Oil strainer. Torque the bolts to 84 inch lbs. (9.5 Nm).
   
4. Apply a continuous bead of Loctite Ultra Blue 587® silicone sealant around the oil pan.
   
   Oil pan. Torque the bolts to 84 inch lbs. (9.5 Nm). Transmission under cover. Torque the bolts to 84 inch lbs. (9.5 Nm). Gusset plates to the engine. Torque the bolts to 33 ft. lbs. (45 Nm). Engine under cover Front axle housing into position. When properly aligned, torque the bolts to 48 ft. lbs. (65 Nm). Intake manifold bracket bolts. Torque the bolts to 34 ft. lbs. (65 Nm). Negative battery cable
   
5. Fill the engine with clean oil.
6. Start the vehicle and check for leaks, repair if necessary.

SOURCE: price on replacement timing belt 2005 kia sportage

358.00 to 458.00 depending on if you have water pump replaced at same time.