SOURCE: 2003 nissan altima 2.5s transmission rough shift
Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.
SOURCE: 2003 Nissan Altima 2.5S, Check Engine Light Problem.
this problem could be caused by the mass air flow censor, i had the same problem with my car. it is really pricey at the dealer so you might want to check elsewhere for this part. I found one at a scrap yard for 85% less that the dealer and i also got life time warranty, the dealer does not offer any warranty on this part.
SOURCE: 94 nissan pickup se how to reset check engine light
disconnect the negative battery cable re hook it back on.. this is only a temp solution if there is a problem it will come back on in the next 100 miles
SOURCE: check engine light on a 1997 nissan altima
gadiame: The code P1400 is for the EGR valve and Evap canister purge control solenoid valve circuit.
An improper voltage signal is being sent to the ECM through the solenoid valve.
As far as whether the engine using a timing belt or gear? You mean chain? This engine uses a timing chain.
If I can answer any other questions, write me.
SOURCE: how to reset check engine light on nissan altima
put a obd2 comp on the car and clear the codes.
or goto auto zone and ask one of them to use there obd2 and clear the trouble codes for you for free.
you can try disconnecting the positve or negitive terminal on the battery and then going in the car and starting the car to drane all power from the system yes act like your going to start the car and hold the key on for about 2 or 3 seconds.then go get a glass of tea and then put battery back on and restart car.drink tea.
1,941 views
Usually answered in minutes!
×