2006 Lincoln Navigator Logo

Related Topics:

A
Anonymous Posted on Feb 03, 2014
Answered

How to replace the cht sensor on a lincoln navigator

5.4l

Answer This Question

1 Answer

Mr Macc

Mr Macc

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Oct 20, 2018
Mr Macc
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

Joined: Oct 20, 2018
Answers
1
Questions
0
Helped
913
Points
2

The CHT sensor is in the back of the pass side the head 1" from the 02 sensor. Im very sure because i just found it myself. I think i can assess it through the wheel weld. Your Navi was be in limp mode until its replaced. Thats was it sounds bad and no power.
good luck

1 Related Answer

Anonymous

  • 12 Answers
  • Posted on Apr 06, 2009

SOURCE: tp sensor replacement

it should be on your throttle body under the hood of your car

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2001 Lincoln Navigator 5.4. Where is the fuel pressure regulator on it please?
On top of the fuel tank according to this. $34 for a new one.

2007 Lincoln Navigator Fuel Pressure Sensor - Q&A

 JustAnswer https://www.justanswer.com > Lincoln Repair
Jan 22, 2021 - 2007 Lincoln Navigator. Where is the fuel pressure sensor located? - Answered by a verified Lincoln Mechanic.

1 answer · Top answer: The fuel tank pressure sensor is located in the top of the fuel tank next to the....


https://www.google.com/search?q=2004+%22lincoln+navigator%22+fuel+pressure+regulator+location

..
Read full answer
Nov 10, 2023 • 2001 Lincoln Navigator
0helpful
1answer

2000 lincoln ls v6 code p1289
P1289 - Cylinder Head Temperature (CHT) Sensor Circuit High Input (PCM STRATEGIES 1999 AND BEYOND) Indicates a CHT sensor circuit malfunction (open).
  • Open circuit in CHT harness
  • Damaged CHT sensor
  • Improper harness connection
  • Damaged PCM
Using signal simulation, disconnect sensor and simulate a voltage on sensor signal circuit. Simulated 1.0V signal and scan PID voltage value should be similar. If voltage is similar check sensor, if voltage is not similar check related circuit and PCM. Note: DTC P0118 may also be reported, this will activate the MIL light.
Read full answer
Dec 22, 2019 • Lincoln Cars & Trucks
0helpful
1answer

4.6 L. V8 Triton. Where is the CHT sensor located?
Cylinder Head Temperature (CHT) Sensor -4.6L and 5.4L Removal
  1. Remove the intake manifold; refer to Section 303-01B .
  1. Remove the cylinder head temperature (CHT) sensor.
    1. Disconnect the connector.
    1. Remove the CHT sensor.
Read full answer
Feb 22, 2016 • 1998 Ford F150 Regular Cab
0helpful
1answer

I have a 2000 crown vic and my coolant fan wont come on unless i cut the a/c on or unplugged the cylinder head sensor i changed thermostat and temp sensor it still same thing what could be the problem
You have a wiring problem from sensor to the PCM - engine computer .
DL22 CHECK CHT SIGNAL CIRCUIT FOR SHORT TO GROUND
    Note: Refer to the PCM connector pin numbers in the beginning of this pinpoint test.
  • Disconnect PCM.
  • Measure resistance between CHT signal and SIG RTN circuits and then between CHT signal and PWR GND circuits at the PCM harness connector.
  • the PCM is what controls the cooling fan !
  • This Pinpoint Test is intended to diagnose the following:
    • Cylinder head temperature (CHT) sensor (6G004)
    • Harness circuits: CHT, VREF, and SIG RTN
    • Powertrain control module (PCM) (12A650)

    Tables and Graphs

    On applications that do not use a ECT sensor, the CHT sensor is used to determine the engine coolant temperature in place of the ECT sensor. In this case the PCM may store both CHT and ECT Diagnostic Trouble Codes (DTCs). To cover the entire temperature range of both the CHT and ECT sensors, the PCM has a dual switching resistor circuit on the CHT input. A graph showing the temperature switching from the COLD END line to the HOT END line with increasing temperature and back with decreasing temperature is included. Note the temperature to voltage overlap zone. Within this zone it is possible to have either a COLD END or HOT END voltage at the same temperature. For example, at 90°C (194 °F) the voltage could read either 0.60 volt or 3.71 volts. Refer to the table for the temperature to voltage expected values.
    Voltage values were calculated for VREF = 5.0 volts. These values can vary 15 percent due to sensor and VREF variations.
  • DL1 DTC P1288 OR P1116: CHECK OPERATION OF CYLINDER HEAD TEMPERATURE SENSOR
    • Run engine at 2000 rpm until engine temperature becomes stabilized.
    • No Starts or Vehicle that Stalls:
      • GO to DL3 .
    • Check that upper radiator hose is hot and pressurized.
    • Rerun Key On Engine Running (KOER) Self-Test.
    Is DTC P1288 or P1116 present? Yes No GO to DL2 . Engine temperature was not stabilized. REPAIR any other DTCs as necessary. DL2 CHECK VREF CIRCUIT VOLTAGE AT TP SENSOR
    • Refer to schematic at the beginning of this pinpoint test.
    • Disconnect throttle position (TP) sensor.
    • Key on, engine off.
    • Measure the voltage between VREF and SIG RTN circuits at the TP sensor harness connector.
    Is voltage between 4.0 volts and 6.0 volts? Yes No There is sufficient VREF voltage. RECONNECT TP sensor. GO to DL3 . GO to C1 . DL3 CHECK RESISTANCE OF CYLINDER HEAD TEMPERATURE SENSOR WITH ENGINE OFF
    • Disconnect CHT sensor.
    • Measure resistance between CHT signal and SIG RTN pins at the CHT sensor. Refer to the table at the beginning of this pinpoint test for resistance specifications.
    Is resistance within specification? Yes No For No Starts or Stalls, RETURN to Section 3 , Symptom Charts.

    All others, GO to DL4 . REPLACE CHT sensor. You need a scan tool to do some of these tests
  • DL4 CHECK RESISTANCE OF CHT SENSOR WITH ENGINE RUNNING
      Note: Verify that engine is at operating temperature before taking CHT readings.
    • Run engine for two minutes at 2000 rpm.
    • Measure resistance between CHT signal and SIG RTN pins at the CHT sensor. Refer to the table at the beginning of this Pinpoint Test for resistance specifications.
    • Key off.
    Is resistance within specification? Yes No REPLACE PCM (refer to Section 2, Flash Electrically Erasable Programmable Read Only Memory (EEPROM) ). REPLACE CHT sensor. DL5 DTC P1289 OR P1290: ACCESS CHT PID AND CHECK VOLTAGE
    • Connect scan tool.
    • Key on, engine off.
    • Access CHT V PID.
    Is the CHT V PID less than 0.2 volt? Yes No GO to DL6 . GO to DL7 . DL11 CHECK CHT SENSOR SIGNAL AND SIG RTN CIRCUITS FOR OPEN IN HARNESS
      Note: Refer to the PCM connector pin numbers in the beginning of this pinpoint test.
    • Disconnect PCM.
    • Measure resistance of CHT circuit between PCM harness connector pin and CHT sensor harness connector.
    • Measure resistance of SIG RTN circuit between PCM harness connector pin and CHT sensor harness connector.
    Is each resistance less than 5.0 ohms? Yes No REPLACE PCM (refer to Section 2, Flash Electrically Erasable Programmable Read Only Memory (EEPROM) ). REPAIR open circuits. free wiring diagrams at www.bbbind.com
Read full answer
Jul 13, 2015 • Cars & Trucks
0helpful
1answer

Where is the CHT sensor on 2000 lincoln navigator
in the cylinder head. it is a temp sensor that is not part of coolant temperature circuit but rather the cylinder head temperature
Read full answer
Apr 26, 2015 • 2000 Lincoln Navigator
0helpful
1answer

Can not find the location of the CHT sensor for a 2001 ford expedtion please help find
CHT- Cylinder Head Temperature Sensor

I do not know the exact location
On my Lincoln LS, it is in the intake side of
the cyl head & not really too accessible

They are used instead of a Coolant Temp
Sensor and will also be one of 2 Fail Safes
that can occur. The other is the Throttle Body
Motor (TACM) ETC Failsafe

I wouldn't rush off to replace it,without knowing
how to test it.

I will check here in awhile & let you know if I
can shed some light on it.

Obviously a professional scan tool is always
the place to start.
Read full answer
Apr 26, 2011 • Ford Expedition Cars & Trucks
3helpful
2answers

Can not find the location of the coolant temp sensor on my 2005 Lincoln ls
CHT-Cylinder Heat Temperature Sensor

V6--Driver Side--between COP Coil 5 & 6

V8-work in progress & I own one

NO CTS Sensor,odd I know
Read full answer
Mar 05, 2011 • 2002 Lincoln LS
5helpful
2answers

Po320 code and code po303 2004 lincoln navigator
Replaced a camshaft sensor still running rough & engine light still on, 2004 lincoln nav. 5.4 liter
Read full answer
Jan 02, 2010 • 2004 Lincoln Navigator
1helpful
1answer

I have an error code p1405 on my 2004 lincoln navigator - what is
DPFE Sensor upstream hose bad. Google DPFE Sensor location. Then remove and replace or clean hoses, Clean connectors at sensor. If this does not clear problem replace Sensor.
Read full answer
Mar 22, 2009 • 2004 Lincoln Navigator
29helpful
4answers

Location: Coolant Temp Sensor 2001 Lincoln LS V6
It is on the Driver side of engine in between the COP's (Coil on plugs) simply unplug the wire use a 19 or 3/4 deep well socket and unscrew it and put it new one... The whole process should only take 10-15 minutes.
Read full answer
Jan 11, 2009 • 2000 Lincoln LS
Not finding what you are looking for?

View Most Popular

2006 Navigator

  • Cars & Trucks

Related Question

2001 Lincoln Navigator 5.4. Where is the fuel pressure regulator on it please?

  • 2001 Lincoln Navigator

923 views

Ask a Question

Usually answered in minutes!

Popular Questions

Lincoln navigator air suspension is all the way down

2004 Lincoln Navigator

THE LINCOLN NAVIGATOR HEATER IS NOT WORKING IS

2001 Lincoln Navigator

Air Suspension problem with 2003 Lincoln Navigator

2003 Lincoln Navigator

The rear lift gate on

Lincoln Navigator Cars & Trucks

Where is the latch located to open the hood of a

2001 Lincoln Navigator

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Lincoln Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
06navog2e.pdf. user-manual-2006...

2006 Navigator

Loading...