Ok, I have a 1997 Pontiac Sunfire SE. Someone stole the battery and broke the negative cable when doing so. I replaced the battery and cable, the dash lights continually flash while the car is being driven and gauges drop as if it was going to die, then my sister was driving it and it died, not sure the exact circumstances, but the car will not start. Have checked the charge, the fuel, and a few other items. What else should I check and could the anti theft system have something to do with this and if so how do I reset it?

Pontiac Sunfire Questions - car won't start - CarGurus

www.cargurus.com > Questions > Pontiac > Sunfir

CarGurusAug 16, 2011 - car won't start - replaced ignition lock on 2002 pontiac sunfire antitheft light is ... system goes into fail safe mode and you won't have any more problems. ...lock cylinder on 2003 pontiac sunfire....when new lock cylinder was ...

sounds like you should junk it,so many questions, 1997 sunfire gt shifter cable Bing images

se encendio la luz de theft sistrem y no se aue hacer

HEATING AND AIR CONDITIONING Blower Motor REMOVAL & INSTALLATION Fig. 1: Remove the sound insulator from underneath the passenger side of the instrument panel
Fig. 2: Remove the retaining bolts for the blower motor assembly
The blower motor and fan are serviced as an assembly only.

1. Disconnect the negative battery cable.
2. Remove the passenger side sound insulator.
3. Detach the electrical connections from the blower motor.
4. Remove the blower motor retaining screws, then remove blower motor and fan assembly. To install:
   
5. Install blower motor and fan assembly, then secure using the retaining screws.
6. If equipped, connect the blower motor cooling tube.
7. Attach the electrical connections to the blower motor.
8. Install the right side sound insulator.
9. Connect the negative battery cable.

When jumped off ,if it drags to start,have the starter checked,and if when jumping the car off,the starter turns the engine over real good,then the cables are most likely the problem,replace them.

Do you have an ammeter or know someone that does? You need to do a parasitic draw test to fix it.

You need to get the radio code which will cost you, Search for radio codes online or call the dealer. The dealer will not give you the code intil you can prove you own the car but since this is a replacement from another vehicle someone will need the model and serial number of the radio.
I personally would of had a aftermarket one installed. It would of saved you alot of aggravation.

Remove or disconnect the following:

• Negative battery cable
  
• Air inlet duct
  
• Top starter bolt
  
• Lower starter bolt
  
• Starter electrical connectors
  
• Starter motor
  

Exploded view of the starter motor—2.4L engine

To install:

1. Install or connect the following:
   
   • Starter motor. Torque the bolts to 66 ft. lbs. (90 Nm) for 2.4L engine or 37 ft. lbs. (50 Nm) for the 2.2L (VIN 4) engine or 30 ft. lbs. (40 Nm) for the 2.2L (VIN F) engine.
     
   • Starter electrical connectors
     
   • Air inlet duct to the throttle body
     
   • Negative battery cable
     

Positive goes to the starter motor and negative goes to the engine block for grounding.

HI. please remove the negative battery post before you being this repair. Make sure you have depressurized the tank as well.

Replace the negative battery post after you have finished the sending unit repair.

The cpu will automatically reset once the negative battery post is reattached and the engine fuel pressure builds back up to its normal pressure.

Please rate and have a great day:)