David it sounds like maybe you might have had your ECU go bad, but I'm not sure.
SOURCE: astro van wont start
check your throtle position sensor, it controls the mixture of the fuel if it's bad and stuck shut your car wont start
SOURCE: 1987 Chevy Suburban 350 2wd not starting or running right
What size engine do you have in it? And, how many miles on it?? Well, I guess it really doesn't matter. At first thought it sounds like you are experienceing a fuel problem, and changing the throttlebody didn't solve your problem. I would start by looking and checking my fuel delivery system. The fact that you had to spray gas into the throttlebody tells me that fuel is not getting there. I would start with the least expensive thing to fix first. Check your gas filters. These are often , OFTEN, overlooked as a sorce of problems, and are rarely changed and often overlooked, and are the problem alot of the time. If that dosen't cure your problem check your fuel pump. Make sure it is delivering the proper pressure. I would bet your problem would be solved, but if it's not then next I would check the electrical components of your fuel system.
SOURCE: throttle body injectors not fiering but there is fuel pressure
the injectors are fired thru the engine cotrol module but it gets its signal to fire from the pick-up located inside the distributor if you are loosing injector pulse only the ignition module is bad if you are also loosing spark when you loose injector pulse your pick up is causing the problem if you replace the pick-up i recomend you change the ignition module when doing so because they work together and you have to remove the distributor to change the pick-up
SOURCE: Truck will turn over but not start. Checked fuel
The ignition module located inside of the distributor is what generates the signal that the ECM (Engine Control Module) uses to time and fire the fuel injectors, as well as the signal to run the fuel pump and the dwell signal timing to fire the ignition coil. A faulty ignition module can cause any one of these systems to malfunction.
That does sound like a malfunction with the ignition module inside of the distributor, and you can remove the ignition module and have it tested for free at most auto part stores.
If you do purchase a new ignition module be sure that it does come with a silicone grease or a die-electric compound because it is a heat sink and the ignition module will burn up without it.
To install the new ignition module first clean out the mounting surface inside of the distributor. Then completely coat the metal contact surface under the ignition module with a thick coat the silicone grease or die-electric compound and do not leave any of the metal contact surface of the ignition module un-coated with the silicone grease or die-electric compound, and be very careful not to over-tighten the ignition module or it will be damaged.
67 views
Usually answered in minutes!
×