2006 Ford Expedition XLT Logo

Related Topics:

A
Anonymous Posted on Jul 09, 2017

2006 Expedition 5.4L Starting problems, changed the corroded Fuel Pump Diver Module, started right up but then again started having issues starting. Seams like when I turn the key several times and let it sit in the accessories on mode for a while I get it to start. Once started it runs fine until I shut it off then same scenario as described. always get it started but it is taking longer and longer now???

1 Answer

Bill Boyd

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Ford Master 53,816 Answers
  • Posted on Jul 09, 2017
Bill Boyd
Ford Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jan 04, 2013
Answers
53816
Questions
7
Helped
11946504
Points
172802

Have the starter switch checked/replaced
only the switch and not the key barrel or you will need to reprogram the key fob and immobilizer

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Aug 15, 2008

SOURCE: trouble starting

check the started solinoid on the passenger fender. Mine would do what you are describing until i put in a new soleniod.

Ad

Anonymous

  • 20 Answers
  • Posted on Aug 17, 2009

SOURCE: I have problems starting my 2003 Ford Expedition.

could be pump and check or replace the fuel filter.

Anonymous

  • 173 Answers
  • Posted on Sep 23, 2009

SOURCE: 2003 Expedition hard to start

HI ' sounds like a liking fuel pump check valve ,to test install a fuel pressure tester follow instruction on tester ,turn key on don't crank engine over turn key off and back on again note your fuel pressure should be 38 psi to 48 it should keep 20 psi in system after 10 minutes of just siting replace fuel pump if you loose the pressure

Anonymous

  • 2309 Answers
  • Posted on May 21, 2010

SOURCE: i have a 2003 ford expedition starting problem

hook up a fuel pressure guage and check it at start up, key on pressure should build and hold , if not check it could be regulator of leaking injector

Anonymous

  • 7353 Answers
  • Posted on May 25, 2010

SOURCE: will not start. turns over when i spray starting

First you need to verify that the pump is getting power. Did you check the Inertia Switch? Power goes through that switch to the fuel pump. If the switch is good, and getting power,the fuel pump is most likely bad, the fuel tank must be lowered to replace the fuel pump.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2006 Ford F-150 crank no start, but only INTERMITTENTLY. Won't start now, but will 4 hours later. Fuel pump control module was deteriorated, so replaced that. Condition did not change with new module.

Scan for Diagnostic Trouble codes.
Put it on a Pro Grade scan tool computer and check Live Data at the time it fails. Check fuel pressure, especially as the control module was causing issues. The electronics will tell you the reason.
1helpful
1answer

2006 ford expedition will not start after driving, let it set 30 minutes and it will start right up and runs fine

Have pressure test run on your fuel pump. before fuel pumps fail they have intermittent issues like you described. Mine just did the same as yours and I replaced the fuel pump and fuel filter. she runs and starts like new.
2helpful
1answer

2000 ford expedition 5.4 litter 4x4 Eddie baur with air suspension starting problems sometimes it will start now it won't start at all it cranks .

IF IT WILL RUN WITH STATER FLUID YOU HAVE A FUEL ISSUE. SINCE PUMP SOUNDS DIFFERENT I WOULD START THERE. CHECK FOR VOLUME & PRESSURE ON FUEL RAIL IF IT NOES NOT THEN THE PROBLEM IS IGNITON, CHECK FOR SPARK
0helpful
1answer

Where its the fuel pump relay on my 06 expedition?

The fuel pump relay is not servicable, it is integral to the central junction box.
0helpful
1answer

2006 nissan sentra fuel pump

there is another fuel pump inside the fuel tank... this might already been corroded/blocked.
0helpful
1answer

My 2000 expedition start but wont turn over sometime unless i spray starting fluid in it then it comes right on

Turning over the engine, is not the same
thing as a no start condition

Won't turn over, means the starting system
is dead

Do you have the correct fuel pressure at the fuel rail
with a pressure gauge or on scan tool data, when the
key is turned on & also when running

About 42 lbs pressure

I would suspect you have issues other then fuel
& the spraying is just a coincidence

I think only scan tool or oscilloscope data on
several sensors, will be needed to see what's
missing on start up
0helpful
1answer

Why does my 2006 mitsubishi endeavor limited has problems starting right away?

Hello --
I thought I already replied to this question -- here is a repeat if so, otherwise, please see the bottom addition - Ck
Look for faults in the fuel injection system, Battery terminal connection loose or corroded; faulty fuel pump; excessive moisture on or damage to ignition components; worn/ faulty or incorrectly gaped spark plugs; broken, loose or disconnected wires at the distributor/ coil pack or starting circuit; faulty ignition coil pack..

ADDITION: I know this sounds weird, but you may want to try playing with the gas cap -- open and close the cap when you go to start it. there may be an issue with the cap.. of vapor lock in the fuel tank, also - when was the fuel filter last changed? How about the fuel tank -- have you added any cleaners or water removeal additives (LIKE LUCAS GAS TREATMENT - not the alcohol only additives which only dry out the fuel)?
Best regards
Ck
2helpful
3answers

2006 Ford Expedition blowing Fuel Pump Relay fuse

Try resetting fuel pump. I do believe the reset button is on the forward passengers side of vehicle. The button is behind the plastic shield. Reset once or twice. This hopefully will fix your problem. Look in your manual for exact placement of fuel pump reset button
0helpful
1answer

2006 vw jettA 2.5....trouble starting

I had to take my car back to the dealership twice. First, they replaced the ignition switch. 3 days later, my car wouldn't start again. So I took it back and they called VW - VW said to replace the steering column module. I asked my dealer why they didn't replace the steering colum module first - they said that even if they had replaced that first, the old ignition switch would have shorted out the steering column module. Whatever.
$600 later my car has been fine for about 3 weeks now. If it happens again I will keep you posted.
Good luck!
0helpful
1answer

1989 Park Avenue dying after 60 miles, restart immediately then

sounds like the ignition module but it could be a fuel problem
Not finding what you are looking for?

218 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...