06 element dies in am

You need a 625 cold cranking amp battery . The more the better.

If it fits and has the cranking amps you need. Use what ever brand you want.. Deka are good batteries though.

whats the question?

tune it up yet? which engine?
stalls hot or cold engine or both?
can you save the stall. by fast right foot action????

1. easy?
2. kinda hard?
3. impossible?????

no need guess; we can diagnose it.

there are lots of causes (50) for but just 4 in physics.
1: bad 12vdc power to EFI. system.
2: lost engine compression, 1 or more cylinders.
3: lost spark to 1 or more cyl.
4: bad fueling, too much or too little.
and other odd causes, EGR stuck open tops that list.

1 part down 49 to go on a guess? really?

enter the security code.

FOR A 2.4 LITER ENGINE
Air Cleaner Element Inspection/Replacement

1. Remove the air cleaner bolts (A) and the Air cleaner Housing cover (B).
2. Remove the air cleaner element (C) from the Air cleaner Housing (D).
3. Check the air cleaner element for damage or clogging. If there is damage or clogging, replace the air cleaner element. Do not use compressed air to clean the air cleaner element.
4. Clean and remove any debris from inside the Air Cleaner housing.
5. Install the parts in the reverse order of removal.
6. Good luck
   

I found that some of the factory codes are 00000, then when the customer buys the car, they can put in their own code.
Look in the owners manual that's in the glove box (if you have one) under radio, and see if it says anything about the code.
If all else fails, the best thing to do is call a honda dealer, maybe they can help.

I just had my battery die from the car sitting 6 days. Battery was dead. Put on 40 amp charge for 30 minutes, then turned key on, off three times. Then key on, foot on brake steady, shift car slowly through each gear until reaching D. Then back to park. Key off and on and start!

go to the dealer that you bought it from and they will give you the code

remove a few of the clips on the inner fender liner, depending on which bulb u are replaceing(left or right?) turn the wheels in either direction and u will be able to slide ur hand or arm between the liner and fender to gain access to the bulbs and connectors..do not remove the battery .