Knock sensor i broke the knock sensor in the block what can i do to fix this

The knock sensor on a 2003 Honda CRV is located on the engine block. Specifically, it is located under the intake manifold, which means it can be difficult to access. Here are the steps to locate and replace the knock sensor on a 2003 Honda CRV:

1. Disconnect the negative battery cable to prevent electrical shock.
2. Remove the intake manifold. This involves removing several bolts and electrical connections.
3. Locate the knock sensor, which is located near the rear of the engine block, under the intake manifold.
4. Disconnect the electrical connector from the sensor.
5. Remove the sensor from the engine block. This may require a special tool, depending on the specific design of the sensor.
6. Install the new knock sensor, making sure it is properly aligned and tightened to the correct torque specification.
7. Reconnect the electrical connector to the sensor.
8. Reinstall the intake manifold, making sure all bolts and electrical connections are properly secured.
9. Reconnect the negative battery cable.

Note that if you are not experienced with working on engines or are unsure of how to proceed, it may be best to seek the assistance of a qualified mechanic to replace the knock sensor on your 2003 Honda CRV.

knock sensor always located on cylinder block ,fix with one bolt (middle of the sensor ) at left or right side of the cylinder block

the knock sensors are located underneith the intake manifold on either side of the engine block. you have 2 of them

A knock sensor is threaded into the engine block and is supposed to sense when the engine starts to ping or spark knock and reduces the ignition timing accordingly.The knock sensor is located on the side of the engine.

Turn the ignition OFF.

Raise the vehicle.

Disconnect the knock sensor harness connector.

Remove the knock sensor attachment bolt and the knock sensor.

Important: The larger metal contact area of the knock sensor MUST be toward the engine block. DTC P0327 may result if the sensor is installed backwards.

Install the knock sensor and attachment bolt with the larger metal contact area toward the engine block.

Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

A knock sensor is usually on the mid way down on the side of the block from the top .It wil have a one wire connector on the sensor.A round looking item screwed into the block. This is what the v/8's used to use to compensate for the compression knock,and i think this adjusted the ignition timing by the useage of the computer.

Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

the knock sensors are on the side of the engine block. they screw directly into the block. most easily accessed with the car raised up

knock sensor located on block, looks like a bolt with wires, just replace it, price on knock sensor vary in price depending on car make

this problem is very seldom the knock sensor, it can be the harness connector at the sensor or the engine has excessive knock which will set a code, u did not mention the particular code so hard to say, the location of the knock sensor is the lower section of the engine block, it is screwed into what would normally be a block drain plug, if u replace it u need to torque it to whatever the factory spec is or it can cause it throw another code..

The knock sensor threads into the side of the cylinder block.

1. Disconnect electrical connector from knock sensor.
2. Use a crow foot socket to remove the knock sensors.

INSTALLATION
The knock sensor threads into the side of the cylinder block in front of the starter.

1. Install knock sensor. Tighten knock sensor to 10 Nm (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance, possibly causing improper spark control.
2. Attach electrical connector to knock sensor