Left turn signals work but flashing quickly. Left brake light goes out but bulb is good.
Usually a ground problem in the harness or the lamp socket.
SOURCE: Chev Cavalier 2003 only one rear turn/brake/hazard light
I have a 2002 Chev Cavalier that had the same exact problem. I replaced the bulb harness (purchased from a chevy dealership for around $5) which was fairly easy to do. I have had zero problems with it since.
SOURCE: 2001 Ford Ranger right turn signal doesn't work when the braking
Flasher Unit sounds bad... change the flasher, which is in the inboard fuse panel.
SOURCE: Brake light/turn signal no not work on left side only.
check fuse number 7 in Engine Compartment Fuse Box , if its ok you need change turn signal switch
SOURCE: Brake light, reverse light and turn signal issues
Hello. The symptoms you are describing are likely due to a poor ground. Temporarily install a new ground wire by securing a piece of copper wire to the frame with a self tapping screw. Use this ground wire along with the hot wire to see if each of these lights works. If it does, trace the ground wire back to the frame, unscrew it and clean up the metal with emery cloth so you reestablish a good ground.
SOURCE: 2004 Dodge Durango: Left turn signal blinks fast
Check the bulb socket for a burnt or a shorted condition. Remove bulb and try another bulb, if it does it again then you have a short in the socket or wiring to bulb. Turn on the 4 way flashers and see what it will do. If it continues then look for any burnt wire connector or wireing to bulb. Check the wiring behind the light for any metal that has cut into the wiring insulation. Hope this will help you.
123 views
Usually answered in minutes!
×