Fuel pump isn't sending fuel to tbi injectors
SOURCE: no power tp the fuel pump, injectors not pulsing, no fuel.
Check out your oil sending unit, fuel pump and relay, check for power (might be a fuse), the ignition control module (which if you remove it, can be tested for free at AUTO-ZONE), any related wiring, pick-up coil (inside the distributor), and possibly the ignition switch. If I can be any more help just as away.
SOURCE: 1987 chevy s10 2.5l tbi will not start. changed
That eliminates the crankshaft and camshaft position sensors. Have you checked the fuel injector itself for an open winding or stuck valve plunger? There should not be a steady 12 volts to the injector--if good injector, it would be spraying fuel steadily into the throttle body. But at least the engine should try to run if poorly. Take the injector out, dry it off with air, and intermittently apply 12 volts to one terminal while grounding the other. You should hear a click from inside every time you touch 12 volts. If not, replace it. If it does, it may be plugged with debris. Try blowing through it in reverse with compressed air.
SOURCE: 1987 chevy S10 engine idle problem
relace the throtle air idle valve.The temp switch will allso cause this problem.
SOURCE: Where is the fuel regulator located on a 1988 tbi
No, low fuel pressure is caused by a weak fuel pump.
High fuel pressure is caused by a faulty fuel regulator.
SOURCE: 90 chevy k1500 350 tbi fuel problem starts but wont stay running
try bypassing the oil pressure switch on the back of the block behind the distributor, if there oil pressure switch goes bad it will do this. had one that drove me nuts trying to fix it then figured out I had to buy a book and low and behold thee it was 3 wire oil pressure switch you can't see between the engine and fire wall just behind the distributor and costs 8 bucks to buy new.
589 views
Usually answered in minutes!
×