Question about 1998 Mitsubishi Montero Sport

1 Answer

Where is the sparkplugs and how do I remove them

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 14 Answers

Follow the spark plug wires from the distributor cap, down to the block. This yahoo write up will help. If you have direct ignition (coil packs) then you will be looking for small blocks above each spark plug. Look for ignition coil packs at webites like oreillyauto.com for a visual of what you are looking for.
How do you change the plugs on 98 mitsubishi montero sport Yahoo Answers

Posted on Jan 31, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changing plugs , is there any parts that have to be removed before you take plug sout?


Sometimes a plastic cover needs to be removed. Otherwise it's just unplugging the sparkplug caps and insert the sparkplug tool to loosen the sparkplug. Make sure nothing falls into the open sparkplug hole once it's out.

Jun 30, 2011 | Hyundai Accent Cars & Trucks

1 Answer

Diagnostic states 3rd cylinder mis fire


Hello, Depending on the Year of the car, the cars that had a sparkplug with a remote coil, you could have a bad sparkplug wire or a bad coil-pack or a bad sparkplug. For newer cars, the coil is attached to the sparkplug directly on top.

For those newer designs, the coil would need to be tested for that cylinder. Using an Ohmmeter, with 1 lead on top and the other on the tip which touches the sparkplug, it is a 10,000Ohm resistance.

Accessing the sparkplug coil is different for several engines. You may have to remove the Intake manifold to reach the coil and you may need to remove part of the fuel rail to remove the Intake manifold. Switching out a plug or coil is easy once you can get to it.

You can have your scans done free at Autozone, Oreillys, or Advance autoparts and they will clear the problem codes once you replace parts. I hope this Solution is very helpful to you.

Jun 18, 2011 | Mercury Marquis Cars & Trucks

1 Answer

How do I get to the spark plugs on a 2004 vw passat 1.8t engine


This all depends on if its got coil over plug or sparkplug wires, whichever remove the coil or the sparkplug wire and then remove the sparkplug, this engine may have covers that cover the plugs, just remove the covers and make sure to label any wires you remove to get the covvers off.

Feb 02, 2011 | 2004 Volkswagen Passat

1 Answer

How do I remove the rear three spark plugs on a toyota avalon 1998


Hi, to change spark plug first remove coil over connecting clip ensuring to depress connector release. Next remove coil over retaining bolts. Remove coil over carefully directing coil toward driver side until rubber end able to flex out of sparkplug access tube. Remove sparkplug using sparkplug socket with rubber insert. Had to remove ratchet to gain enough clearance. At this point you should be able to remove sparkplug by tilting extension & socket toward drivers side of car. Then lay horizontal & remove toward passenger side of car. If unable to gain access in this manner you probably have too long an extension. Take care as not to damage spark plug coil over as they are considerably expensive.

Sep 18, 2010 | 1998 Toyota Avalon

1 Answer

How do i change spark plugs in 1992 buick le sabre


To change the plugs, do one at a time so not to mix up the sparkplug wires, remove plug wire from a plug, use sparkplug socket to remove the sparkplug make sure to gap new plugs, ask parts store for the gap setting they will give it to you when plugs are bought, the plug gapper is about $2.00. and that about it, the rear plugs are a little harder to get to but the same way to remove, some buicks came with metal heat sheild over the sparkplug boot in the rear cylinders make sure to reuse, you will know if you have them they will slide right off old boot.

Aug 20, 2010 | 1992 Buick LeSabre

2 Answers

Mazda rx8 use a special tool to remove the sparkplugs?


its a long sparkplug socket wrench,with an extension bar....

Aug 18, 2010 | 2004 Mazda RX-8

1 Answer

How do I get the spark plugs out of my 1998 ford escort to replace with new ones? Also where does the pcp Valve go?


With you hood open and you are standing in front of the car sparkplug wires need to be removed,i suggest you remove them one at a time, under each wire the sparkplug is threaded into the cylinder head,using a 5/8 sparkplug socket remove the sparkplug and replace it with new properly gapped sparkplug.Note:if you remove all sparkplug wires at once the factory wires are generally numbered 1 2 3 4 the sparkplug closesed to the passenger fender is #1 and the one clossesed to the driver's fender is #4.Standing in front of vehicle the PCV Valve is located between #3 and #4 on the backside(intake side) of the engine fitted down into a rubber hose

Jul 17, 2010 | 1998 Ford Escort

1 Answer

How do i change the spark plug in a 1996 isuzu rodeo? It is not ease to pull the plug wires off of the plugs.


You have the 3.2L 6cyl ? The wire connector at each coil that is positioned above the sparkplug is a bit tricky to remove. Start with an easy to get at one-like one on engine front passenger side. There is a clip you have to push in to release the connector-it will slide out. Then remove two screws holding coil to valve cover and pull it up-it will have a long boot on it. Use a sparkplug socket and long extension to remove sparkplug. Tip: driver's side sparkplug located nearest to firewall of car is a bit tricky to get out because of steering/master brake cyl-use two short extensions-when sparkplug is unscrewed from engine-lift it up a bit-remove one extension-then lift plug out.

Apr 06, 2010 | 1996 Isuzu Rodeo

1 Answer

Sparkplugs need replaced


Here are some instructions:

1. open hood
2. disconect battery
3. remove sparkplugs cable
3. use a torque ranch to remove sparkplugs (turn to left)
4. replace with new sparkplugs
5. connect cables
6. connect battery

Start car and check for missfires

Good luck!!!

Dec 29, 2009 | 2000 Mitsubishi Montero Sport

Not finding what you are looking for?
1998 Mitsubishi Montero Sport Logo

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...