1990 Honda Prelude Logo
Anonymous Posted on Jun 04, 2009

My 90 model prelude cuts out after about 10 to 15 mins

I can go back in around 5 mins and it will start again but if i turn it off it wont restrart. i have checked the spark when it does this and it has plenty.at first i thouht it had feul pressure but it doesnt. i would like to find the main relay and replace it before i replace the feul pump.i have looked behind the coin box and only found fuses and looked in the main box under the bonnet and there is only lights,dimmer,compresser and cooling fan relays,any ideas

1 Answer

2smart4u

Level 2:

An expert who has achieved level 2 by getting 100 points

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Expert 73 Answers
  • Posted on Jun 04, 2009
2smart4u
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Oct 25, 2008
Answers
73
Questions
0
Helped
17672
Points
151

Compression? distributor? leads? plugs? relay? electrical wiring circuiting out? any of these is a factor.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 91 honda prelude with a 2.2 v-tec 5spd out of a 92 prelude! I just put a clutch master n slave in for a 92. Genuine honda parts! I bled many times!! Wont go in gear when running til i drive it for...

indicates that there is air in the system
constant movement of the clutch is removing the air but after leaving for for a period , air is again getting back in the system
Possible loose connection at the slave cylinder/bleed nipple or faulty slave cylinder
0helpful
1answer

2003 crown victoria cranks wont start, was running fine, just cut out.never started again

As with any no-start situation, you need to know if you have spark to the plugs, fuel to the injectors, and normal compression to proceed.
0helpful
1answer

Car will run for 3-5 mins then cut off...and wont

Sounds like a fuel pump problem possibly a relay! check fuel pressure at the rail! if no fuel check for power tothe fuel pump witha test light
10helpful
2answers

Renault master van will not start with the key it turns over ok but will not start but it will start with a tow i leave it running for 5 mins it cuts out again

Renault master van will not start with the key it turns over but will not start it will start if i take earth lead off for 5 mins runs for 5 mins and cuts out again.
0helpful
1answer

PRELUDE WONT STAY RUNNING

see http://www.tegger.com/hondafaq/faq.html#general under EFI Main Relay (half way down page). Probably Main Relay fault - read the links etc.
0helpful
1answer

My 90 model prelude runs fine for about 10 to 15 mins then cuts out and wont restart but if you leave it for around 10 mins will start again. if i turn it off again same problem it wont start. it seems to...

ignition modual . net time it dies take one of the pluge wires off and check for spark by sitting it close to a ground and crank the engin . if no spark it very well could be a control mod
0helpful
2answers

1990 Honda Prelude won't start after I stop or konks out during

Sounds like it could be a Main Relay (with controls the fuel pump & others). Look it up - on the '92 models its under the dash near the steering column.
Not finding what you are looking for?

178 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...