Changed sp wires car wont start
you need to run the car and see if the fan comes on if it does change the thermostat and gasket if it does not you need a fan sensor
SOURCE: how to change spark plugs on 2005 acura tl
Hi,
you need a 6 inch extension, short 3/8 ratchet, 5/8 plug socket, 3/8 swivel "u" joint, (sold at sears) 8mm 1/4 drive socket deep well and 1/4 inch ratchet.
find the coil packs (6 total, three in each head.)
remove the two retaining nuts holding each coil pack using 1/4 8mm socket and ratchet.
twist the pack to break the sticking boot below.
pull up (be careful to not rip the boots however it may still happen but rare.)
remove coil packs, the rear is a little more difficult with the intake.
use 6" extension and u joint and ratchet to remove plugs and replace.
reverse order to assemble. Good luck, and hoped this helped.
SOURCE: 1999 Acura 3.2 TL has 87,000 miles changed spark
You need to replace your IAC (idle air control valve). The IAC, like it sounds, control the idle of your car. When they go bad they will cause the low idle and stalling. The IAC is located on the throttle body and is usually held on with a couple of screws. It is an easy relatively cheap fix that you can take care of by yourself. Let me know if you have any more questions. Thanks for rating my response and for using FixYa!
SOURCE: 2000 Acura 3.2 tl with po300-po306 misfire codes
Check and test injection system. 300 is misfirn random and 306 mifrie cyl #6
SOURCE: acura tl 3.2 2000 engine mis fired
the P0301 means Cylinder 1 Misfire Detected, and the P0303 means Cylinder 3 Misfire Detected. I think have known how to fix the problems after you knew where is the problem.
________________________
mini vci for toyota tis
445 views
Usually answered in minutes!
×