Audi A6 2002, Avant Quattro, how do i change the plastic wing mirror cap? thanks
SOURCE: audi a4 1.8t windows, interior light wing mirrors not working
Folks, Just found my problem ...... There's a flexible conduit (corrugated rubber sleeve) between the driver's door and the door arch which contains the wiring loom for the drivers door central locking/door speaker/electric windows/mirrors etc....discovered when I slipped off the sleeve that 4 cables in the wiring loom had broken due to repeated flexing when drivers door was opened/closed over the years (2001 Audi A4). Resoldered broken wires and insulated same....now working better than ever again ...ie dashboard back lighting seems brighter than it had been for some time? Also drivers door loudspeaker is back in action again (hadn't noticed that it had gone).
It's kinda difficult to reseat the rubber sleeving correctly after the repair job...will probably use some silicone sealant on the sleeve to ensure that there is no water ingress to wiring loom afterwards. I'm not too impressed with Audi design people after that, should have used cable that has a better flexibility rating (esp on drivers door!).
Paul.
SOURCE: replacing the wing mirror on an audi A4
TO FIT A NEW MIRROR FIRST CONNECT THE WIRING PLUGS THEN ENSURE THE FRICTION PIN ON THE BACK OF MIRROR ENGAGES IN THE SLOT (OUTER EDGE OF MIRROR) PRESS FIRMLY AT THE CENTRE OF THE MIRROR TO ENGAGE THE RETAINING CLIP....IF YOU NEED TO REMOVE MIRROR INSERT A FLAT TOOL BEHIND THE LOWER EDGE AND LEVER IT FROM THE CLIPS.. HOPE I WAS OF SOME HELP TO YOU...
SOURCE: how to remove and repalce vw golf wing mirror
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can remove the bolts securing the mirror to the door.
SOURCE: remove/replace wing mirror on audi 80
take off the plastic cover on the upper forward corner of the door, you will see three bolt studs with nuts..Remove the nuts, pull the mirror out enough to disconnect the electrical connector.
SOURCE: right side wing mirror
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
170 views
Usually answered in minutes!
×