1996 Nissan Sentra Logo

Related Topics:

A
Anonymous Posted on Apr 14, 2017

Dodge 46re no thidr gear shift

On the way home Thursday the transmission decided it wasn't going to go into 3rd gear, limped home and let it cool pulled the pan checked the govenor and the screen had a lot of build up on it ohm'ed it out and only got 2 ohm's res. replaced in agj. the bands new filter and fluid, put it thru it's paces kick down at fulol throttel everything worked great, this morning on the way to wook I notices early 1/32 shife after it warmed up and then back to no 2/3 shift,first and second are nice and tight. also noticed a little planetary whine now, could this be caused by the anti drain back valve in the cooling line ?

5 Related Answers

Anonymous

  • 18 Answers
  • Posted on Jun 18, 2009

SOURCE: transmission help?

finally got the problem solved, there was a short in the wiring next to the computer, had the short fixed and the transmission is working fine now

Ad

Anonymous

  • 1 Answer
  • Posted on Nov 14, 2009

SOURCE: Transmission slipping

My maxima uses only Matic K fluid. & I think another dealer put the wrong one druing service but no way to prove it. But it's 100% your transmission. I've been complaing since i got my maxima in 05 brand new. within 5000 miles I was complaing its transmission. Now today I have 52000miles now they admit something is wrong Luckly i was under warranty. I've been informed by former mechanics if once dealer does not find anything the 1st time they call all the local dealers & give eachother a heads up no to waste time on that specific car.I had to push the service advisor to go for a test drive to prove my car was having problem.
Good luck man

Anonymous

  • 165 Answers
  • Posted on Dec 09, 2009

SOURCE: I just replaced the engine on a 93 pickup 4 cyl

just an idea, are the tourque converter bolts still there?

Testimonial: "Problem is still on-going because of the deep freeze. I will not have a chance to drop the trans until Fri evening. I will let you know what I found."

Anonymous

  • 12 Answers
  • Posted on Feb 28, 2011

SOURCE: When I drive the car

The Syncro is worn. Fluid will not help. I'm afraid it's time for a rebuild or another used transmission from a junkyard.

don-ohio

  • 946 Answers
  • Posted on Nov 14, 2011

SOURCE: 1989 pathfinder transmission 3spd w/ overdrive works great when first started, then downshifting starts way early, started after alternater wentbad

Do you mean upshifting starts way early? Going from 2nd to 3rd in other words?
Ireally don't know your transmission,but the alternator problem might've possibly spiked and hurt your shifting solenoids in the ******. don-ohio (:^)

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Wont shift gears

Dodge Neon Questions - 04 neon will not go into high gear ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusNov 3, 2012 - 04 neon will not go into high gear - 04 neon won't go into high gear. changed transmission fluid. (it tried to change after fluid was changed) gas cap ... ... Car: 2003 Dodge Neon SXT, automatic transmission. As of today, I have ...

Dodge Neon Questions - 2005 Dodge neon does not shift ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusApr 6, 2014 - Your cars computer gathers info on speed in order to shift gears properly.... then you won't have a speedo and the ECM will not tell the TCM to shift gears in the trans. .... Car: 2003 Dodge Neon SXT, automatic transmission.

Neon wont shift out of first gear auto. - DodgeTalk : Dodge Car ...

www.dodgetalk.com > ... > Dodge Neon - General Talk
Jul 30, 2011 - I have a 2003 dodge neon se and it will run and drive. The transmissonwill not shift out of first gear. Where do I start? Compare to Toyota Tundra. Get Tundra on ... 2000 Stratus won't shift out of First Gear
Mar 14, 2007
Not shifting out of Second Gear???
Jan 15, 2007
46RE wont shift out of first at full throttle.
Nov 17, 2006
Transmission wont shift
Nov 3, 2005
More results from www.dodgetalk.com
0helpful
1answer

99 dodge durango wont shift into 3rd gear

If it's in limp in mode it won't shift out of 2nd gear. Get the trouble codes read. The solenoid pack is a pretty common failure. But don't just throw parts at it. Get the codes first.
0helpful
1answer

46re won't shift into 3rd gear

first of all have you had the car scanned before you try anything else get the vehicle scanned this will give you a direction to work on .if codes are not cleared the vehicle will stay in limp as it thinks its still broken start there give me codes see what i can help you with
0helpful
1answer

I have a 2002 dodge grand caravan with transmission shifting problem. it won't shift out of 3rd, manually or auto. i did a code fault check and it showed the following. P1495,P0888,P0700,P0750. I also...

If it will not come out of 3rd gear, the computer has placed it in "limp home mode" because your overdrive needs attention. Take it to a reputable transmission shop and have it diagnosed. It may call for a rebuild or replace if the clutch packs and drum are burnt out.
1helpful
1answer

Starts out in 3rd gear

Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmision is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the underhood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.
What is "limp-home mode" ? This is a fault mode in which the transmission either loses electrical power or the PCM deactivates all of the electronics. The transmission will default to max line pressure. The driver will have Reverse and 3rd, with manual 2nd available by putting the gearshift in 2 or 1 (doesn't matter). 1st, 4th, and TCC lockup will not be available. It will not hurt the car to drive it like this for short periods, but use manual 2nd to get the car moving, and be aware that the trans will generate more heat than normal while operating in limp-home mode due to increased torque converter slippage during 2nd gear starts and no lockup in 3rd gear.
Before guessing at transmission problems, check the fluid level (car warmed up, engine running in Park on level ground) and have the PCM scanned for trouble codes FIRST. This guide is meant for problems that do not show up as PCM codes (like shift A&B solenoid failures, for example).
Thank you for using fixya and good luck
2helpful
1answer

Will not shift into 2nd gear on a automatic trans

Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmision is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the underhood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.

What is "limp-home mode" ? This is a fault mode in which the transmission either loses electrical power or the PCM deactivates all of the electronics. The transmission will default to max line pressure. The driver will have Reverse and 3rd, with manual 2nd available by putting the gearshift in 2 or 1 (doesn't matter). 1st, 4th, and TCC lockup will not be available. It will not hurt the car to drive it like this for short periods, but use manual 2nd to get the car moving, and be aware that the trans will generate more heat than normal while operating in limp-home mode due to increased torque converter slippage during 2nd gear starts and no lockup in 3rd gear.

Thank you for using fixya and good luck
1helpful
1answer

4L 60E - 2001 k1500 will not shift into 3-4. Oil is not burn't and stifts great into1-2

  • No 3rd or 4th gear: “3-4” clutches are worn out. R&R. The car is safe to drive (in 2) until you can get it fixed.
  • Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.
  • No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : Shift A solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.
Check to see if your transmission is in the limp mode, which would only give you 2nd, 3rd and reverse gears. No 1st or 4th gear.
1helpful
1answer

I have had my tiburon less than a year but about a month ago the transmission started to act weird. At first it began shifting between i think third and fourth gear which made the rpms go higher than they...

the trans computer has seen a problem possible a bad sensor, or an internal problem, and puts it into a safe mode, or limp home mode , it wont shift , it will stay in 3rd gear, this way this reduces the possibility of further damage trans damage, when you turn the ignition off and back on it resets the tcm, my advice is to take it to your local dealer, they can diag your trans as they know the product, i dont advise pep boys, or discount auto parts.
0helpful
2answers

1997 Dodge 1500 ram pickup 360 ci won't shift into 3rd gear

If the truck feels like it is taking off in second gear and will not shift into third then the transmission may be in fail safe or limp in mode. This is generally due to an electrical or control failure in the system. If it is slipping in first and not shifting into third or overdrive then you would have an internal issue. Either way, you are going to need professional diagnosis. If servicing has not helped then I would guess you need professional help on this one.
Sorry and good luck.
1helpful
2answers

Truck wont shift automatic. stays in 3rd gear. can shift manually

either repair or replace the transmission...sounds like the sensor went out
Not finding what you are looking for?

161 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...