My car battery dies for @ two hours i jumped it and then the radio wont work and is flashing code. i read manuel and did what it instructed for entering code provided with car and it still wont work what should i do next? 2003 acura tl?? I BUY AN ACURA CL 2002 BUT ONCE I JUMPED CAUSE THE BATERY DIE THE RADIO SHOWS AN ERR

its locked... you need the VIN and call the dealer to give you the code

Fuse blown?

If you need further help, reach me via phone at https://www.6ya.com/expert/tom_1788908372a4836f

I would check your ground from the battery to the frame/engine and also the positive battery lead where it connects to the starter/relay

OLder cars YEs you can jump it without a battery. But in newer cars that use computers and advanced Eltronic ignition/timing/ful injection you have to have power to the cars computer. without a good battery the car will not run.---------------------------------------------------------------------------------
Renault CAN Clip

think you need a new radio i suspect you put the jump leads on the wrong way around

The anti-theft program has kicked in (usually activated by the wrong code being put in 2 times). Turn the ignition key to position 1, and turn the radio on. After 1 or 2 hours, the word code will be displayed. At this time, if you put in the correct code, the radio should work.

You will need to contact the dealer. Radio codes are only supplied thru the dealer or you can search online for places that sell the code.

Chances are you will need to pay for the code or replace the radio with one that is an upgrade with no code needed.

You must get the 4 digit security code and enter it into the radio by pressing the AM and FM2 buttons at the same time. Then enter code via the preset buttons. Press button #1 until you get the first digit of the code then press button #2 until you get the 2nd digit and so on for the 3rd and 4th digits. when code is on the display press the AM and FM2 buttons again and radio should come back on. if it reads safe you have the wrong code #. You can get the code from a dealer for a small fee. They need to remove the radio to get a serial # on the radio chassis.

I’m happy to help further over the phone at https://www.6ya.com/expert/anthony_dda4e0152e94f3c0

Get a boyfriend stop jumping the car...JUST KIDDING. You must have a reset button, it's not very big , you can push the reset with a pin, it's a small cercle on the right hand side of your radio. Try that and let me know