In a 2004 Silverado 2500, what is the part number for the wiring harness that accommodates all the power, lumbar and heat options for both seats? Mine did not come with these options, but I bought OEM seats that have all the options. The control connections were present in the door panels, but not under the seats. thx
SOURCE: 8 way power seat swap for power heated seat
i put new cars to gether an if it doesnt hav the acessories it wont have the harness u need,,maybe sumtymes they do but if ucan run aseperate switch itll work use the right amp rated wire or ull have more heat (fire)?thats about 12feet of wire they can save they will save if possible(wire harness) too bad i cant fix my own car thou,,,lol..
SOURCE: where does electric trailer brake harness plug into under dash
what are you asking? how do you get the lights to hook up to the back of your truck? you may need a pigtail connector to hook the trailer up and have it work properly.
SOURCE: Need the wiring Diagram for a 1999 Silverado
Your public library will have a manual covering your mechanical repair. Moreover, they have the automotive shops online software called AllData. It is the best auto technician database available today. You can print out specific troubleshooting procedures, diagrams, step-by-step istructions, and soforth. The typical person cannot afford to pay for this service, just automotive dealerships, etc... that is why the public library made it available to everyone and for free to view and print out material. This should Fixya! Good Luck!
SOURCE: 93 silverado 2500need free online mechanical diagram of doors
GM Full-Size Trucks 1988-1998 Repair Information
Doors - REMOVAL & INSTALLATION
R/V Series
See
Figures 1, 2 and 3
If the door being removed is to be reinstalled, matchmark the hinge
position.
Fig. 1: Door hinge-R/V Series
Fig. 2: Door hinge components-C/K Series
Fig. 3: Removing the hinge spring
C/K Series
To install:
ADJUSTMENTSee Figure 4
The holes for the hinges are oversized to provide for latitude in
alignment. Align the door hinges first, then the striker.
C/K series utilize hinges that are welded to the door and frame. No
adjustment is possible except when replacement hinges have been
installed.
Fig. 4: Door adjustment check points
If the door has not been removed, determine which hinge bolts must be
loosed to effect alignment.
Be sure that there is no binding or interference with adjacent
panels.
R/V Series:
Door edge-to-rocker panel: 6mm
Door edge-to-roof panel: 5mm
Door edge-to-rear pillar: 5mm
Door edge-to-front pillar: 2mm
C/K Series:
Door edge-to-rocker panel: 6mm
Door edge-to-roof panel: 6mm
Door edge-to-rear pillar: 4mm
Door edge-to-front pillar: 7mm
Door front edge-to-fender: 5mm
Shims may be either fabricated or purchased to install behind the
hinges as an aid in alignment.
Hope this help, TY for using Fixya (remember comment and rated this). Good luck.
Testimonial: "very helpful just needed abit more info. thx "
748 views
Usually answered in minutes!
×