i had this problem to, do not hook the ground wire from truck to your radio. use the braided wire that hooked to your old factory radio by inserting a bolt into the braided wire and ground from your new radio.
then check fuses one more time and you are good to go.I didnt think this would work but it did..
SOURCE: location of spark plugs in 2005 dodge dakota
To change the sparks on a 2005 4.7L Dodge Dakota you will need the following:
Note you will have to remove the air intake located at the top of the engine, and will have to move some of the coolant lines out of the way.
At the top of the engine there are 4 sparks on each side. The coils are held in place with a 10mm bolt. Undo the 10mm bolt and unclip the coil. Next pull out the coil.
Insert the socket, with extension into the spark plug hole.
Remove spark plug.
Check the gap on new spark plug, it should match stock.
tighten to approximately 25ft.lbs. (check spark-plug packaging for exact torque requirements).
repeat this process with all other sparks.
be sure that no dirt gets into the spark plug holes.
SOURCE: 2004 Dodge Ram 1500, Infinity sound system. CD/AM/FM not working.
You most likely need a new radio. They go bad all the time in the Chrysler/Dodge/Jeep. Don't know how many of them I have replaced.
SOURCE: cd stuck in stereo
Turn the radio off, disconnect the battery for 2min then reconnect the battery. the radio should reset it self for you to eject the CD and just reprogram the time and radio presets. Note you must make sure the radio is off when battery is disconnected or your going to be prompt to enter a radio code to have it work again. Good luck and keep me posted, if this does not work, then your CD player motor has gone bad and your going to have to replace the radio.
414 views
Usually answered in minutes!
×