2005 Kia Sorento Logo

Related Topics:

Posted on Jun 01, 2009

Licht check engine burns

The light check engine burns

1 Answer

Bob Peloquin

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 43 Answers
  • Posted on Jun 04, 2009
Bob Peloquin
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Nov 17, 2008
Answers
43
Questions
0
Helped
26834
Points
67

You need to read the code using a CAN code scanner and reset it. Most common fault is EVAP which indicates the cgas cap may have been loose. Look for rust around the top of the filler neck and clean it off with fine sandpaper then apply light grease and reinstall cap.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a toyota proges check engine licht not sow on my das and crank wont start no feul coming no spark i have check relay fuse eveyting do you ting rail pressure sensor can b the proublem

you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, c omplete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
0helpful
1answer

What causes the stability light abs licht traction light al come on and speedo drops out? Could the abs module be faulty?

one of your wheel speed sensors is bad. If the speedo drops out I think it is the left rear wheel speed sensor. Check that before getting into the ABS module....
0helpful
2answers

My 1998 chevy lumina ls is runnig rough at idle

Rough idle could be the throttle position sensor, or the idle air control valve.abs could be you need brakes or just the abs sensor is bad
0helpful
1answer

Check eng. licht on and flashing od light flashing

it is flashing you the code for what is wrong.goodluck
0helpful
1answer

Check engine licht comes on after driving for a few days wat do i look for?

check your thermostat and make sure you have antifreeze 50/50. My 2000 Chevy impala was blowing cold air, but the previous owner had put some radiator stop leak in the radiator that clogged the whole system. I used a garden hose and flushed the heater core and the water pump.
1helpful
2answers

I have a 2000 trooper that burns oil. I let it

If the engine oil light wont go off it might be the damage is done and you need some major engine work .
5helpful
1answer

Rear left and right turn signal lights not working.

the electronic flasher module may be faulty, or you could have blown a fuse
0helpful
1answer

Check Data Communication Link (DCL)

Look for a missing ground in the circuit. Almost sounds like your missing ground is being sought through other accessories. You will need a ground/power test light - This type lights Green for ground/and Red for power to find the problem.

Start with a schematic
0helpful
1answer

Check Data Communication Link (DCL)

I have this same problem, I had it before, but I can't remember what I did to make it go away. I think it was triggered right after I replaced the air-suspension, with a tranditional one, but I can remrember. I am getting this same problem again, my car has 207K+ miles on it.. --Alfredo
Not finding what you are looking for?

170 views

Ask a Question

Usually answered in minutes!

Top Kia Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...