Cars & Trucks Logo

Related Topics:

C
Carla Whiteman Posted on Jan 22, 2014

Ecm data link problem on an 92 oldsmobile 88

Car starts misting and kills engine

5 Related Answers

kirtec auto

  • 1348 Answers
  • Posted on May 09, 2009

SOURCE: engine check light is on

does the car buck on the highway when accelerating under a slight load?
i owned one of these exact cars,3.8 litre.
2 problems. one,the baffles braek in the gas tank,and if you run 1/4 tank or less it will stall in a turn.
mine it was a right turn.
2nd problem,the EGR valve was stuck and it would surge or "buck" on the freeway.
replaced the egr (exhaust gas return)valve and it ran like new.
if the egr valve is code 42,(i do not have the manual in front of me) you have found the problem
check the egr,it can cause the problems you have.

Ad
c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on May 21, 2009

SOURCE: car will not start, starter will not engage

REMOVAL & INSTALLATION

  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
  3. If necessary for access, remove the splash shield.
  4. If equipped, unfasten the flywheel inspection cover bolts and remove the cover.
  5. Label and detach the electrical connectors from the starter.

Fig. 1: Unfasten the starter motor electrical connections. You may want to tag them first to avoid confusion

5cfb7af.jpg
  1. It may allow more room it you remove the right side cooling fan.
  2. Remove the starter-to-engine bolts, then carefully lower the starter from the vehicle.
Fig. 3: The starter is attached to the engine with 2 mounting bolts (see arrows)

7ead185.jpg
More coming

kirtec auto

  • 1348 Answers
  • Posted on Jul 23, 2009

SOURCE: Idling

the idle air contoller,or thecoolant temperature sensor,which when cold sends info to the ecu to idle fast

Anonymous

  • 2 Answers
  • Posted on Aug 09, 2009

SOURCE: 1994 oldsmobile 88 won't start

if key has a chip in it the lock cylinder is bad it has wires that sense that chip i've got a new one pluged it in at base of steering column with new key in it and used old key as normal

Anonymous

  • 1489 Answers
  • Posted on Aug 20, 2009

SOURCE: my 1989 oldsmobile 88 royale wont start

Sounds like a good idea.

Charlie

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the ECM on a 1995 88 Oldsmobile Royale

Anypartstore can show u. They have data on all yrs
0helpful
1answer

Ecm data link problem oldsmobile

If you mean that you cannot communicate with the pcm with a code reader or scanner.. Then check for a blown fuse on the lighter ckt. This is also the power for the ALDL connector.
0helpful
1answer

1984 oldsmobile delta 88 charging system diagram

can i put an auto start in a 1984 olds delta 88
1helpful
2answers

Cannot locate the ecm for my 88 olds custom cruiser. can you help?

For 1988 Oldsmobile 88 Custom Cruiser 5.0L 4BL OHV 8cyl the Engine Control Computer is located front seating area, passenger side, under dash, mounted behind kick panel.

Hope helps (remembeer to rate this asnwer)
0helpful
3answers

1997 Olds Delta 88, 3800 engine, when started and let idle, when the engine hits about 150 degrees, it stumbles and kills. It starts back up. It has killed at freeway speeds several times. Pull off the...

electrical is the weakest link-you may have a computer with issues and before replacin a reprogram should be considered--what did vehicle scan tell you? Data recorders are often placed in cars that show no codes--Older cars can have solenoids and components that heat up and stop engine--if theres a distributer cap-inspec for corrosion
6helpful
1answer

Where is the ECM located on the '94 Olds 88 Royale?

For 1994 Oldsmobile 88 3.8L SFI OHV 6cyl the Engine Control Computer is located front seating area, passenger side, under dash, mounted above kick panel.

Hope helps (remember to rate this).
0helpful
1answer

My 92 oldsmobile royale starts fine but after engine gets to normal temp the car starts to sputter and drive funny then will stop running.

Lightly tap on the case of the ECM, (silver box behind glove box) while it is running fine to see if it shuts down. If so. Replace ECM. Those were bad about the components on the board inside vibrating loose.
1helpful
1answer

'92 olds 88/3.8 showing code 26. what does it mean

26 means: quad-driver module (computer) circuit #1 fault
replace the ECM.
1helpful
1answer

Oldsmobile Delta 88, Idles High on Cold start with DTCs

Sounds like a vacumn leak. Gasket under intake plenum may be leaking. Be sure the pcv valve has the o-ring around it in the correct place also as it will set a code.
Not finding what you are looking for?

140 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...