Hey guys, Everytime I re-fill the washer fluid in my car, it leaks through the bottom once I apply the pressure to spray. I went under my car and noticed that the nozzle was loose from the pump. I put the nozzle back in, and then it comes out again upon pressure. Is there something that is suppose to hold this nozzle in place?
SOURCE: windshield washer does not pump fluid
The pump works off the same circuit as the wipers, so it would be same fuse. Most likely the pump is no bad.
SOURCE: power steering fluid leak (1999 grand am gt)
sounds like a high pressure hose or rack and pinion would have to get underneath and take a good look at it while someone starts it and turns the whell all the way to tyhe left or right and hold it there till you see the leak
SOURCE: windshield washer fluid wont spray wipers work its
i think the motor is in the bottom of the washer resivore im guessing a little but if i remember right thats where it should be
SOURCE: 1998 Grand Prix GTP windshield washer (full) not pumping fluid
Yes it's easy to do, remove tank pull pump off of tank, and replace pump, Napa has this pump # 6651533 it runs between $14.00 and $20.00 .
SOURCE: I have a 2003 Pontiac gran prix. The windshield
Check on the passenger side where the tubing is routed along the top and the turns the corner where it is supposed to be under the gasket. Mine had not been working for a long time and today when I replaced my serpentine belt, I happened to noticed the the tubing was pinched and cutting off the fluid. I rerouted it under the gasket like it is supposed to be after I straightened out the tubing.
254 views
Usually answered in minutes!
×