SOURCE: changing fuel filter on 2004 chrysler town and country
SOURCE: location of the speed sensor on 1996 town & country
they are on the front drivers side of the transmisson and have two wires coming off them, there are two one is an input shaft sensor and the other is an output shaft sensor unless you have a 4 cyl van then there is only one sensor please rate -jeff
SOURCE: I need location of oxygen sensor on a 2001 town & country
ALL of your oxygen sensors are located i your exhaust system Your exhaust system starts at the exhaust manifold on the side of the engine and ends at the tail pipe by you back bumper. Your vehicle oxygen sensors are 4 of them there are two on each side of your exhaust the are actually screw into the exhaust they are like the nose of you engine to read how rich/lean the car is running. The are pretty simple to replace, they look kinda like spark plugs with wires attached to them the wires are usually colored white black and grey with plug connections on the end. To replace get a oxygen sensor socket and a ratchet and unscrew this socket can be bought at almost any auto parts place like auto-zone etc. Good luck and thanks for using FIX YA
SOURCE: locassion of output speed sensor on 2003 Town and Country
The input and output speed sensors look identical on the connector side. The one over the solenoid pack is the input, the one closer to the left frame rail or left front wheel is the output sensor. I hope this helps.
SOURCE: I have a 2004 Chrysler Town and Country and my
P0440:
P0441:
Bad vacuum switch
75 views
Usually answered in minutes!
×