Engine light on has been reset but comes back,how much is repair going to run
SOURCE: resetting service engine soon light in my 2002 cadillac escalade
SOURCE: No Check Engine Light working
check to make sure the ecm fuse is not blown,also check pin 16 on the plug where you plug in the scanner should be last pin on bottom row make sure this pin has power when the key is in the on position,hope this helps let me know
SOURCE: camshaft position sensor
The camshaft position sensor is on the rear cylinder head on the left end (the serpentine belt end of the engine - passenger side). It is a son-of-a gun to get at. When it is bad or the connector is intermittant or bad, the symptom will be irregular idle from 500 to 750 RPM or so.
SOURCE: abs light/traction control light
You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.
SOURCE: where are the camshaft and crankshaft position
crankshaft sensor is and the hormonic balance pulley and cam sesoor should b and the front of the motor toward the top. But to b sure u should get a book for u vehical
31 views
Usually answered in minutes!
×