Reset security system

Question edited for clarity.
Question moved to model category.

You can't Disarm the system, but there are a number of ways to try and reset it.

https://www.justanswer.com/mazda/e6z2i-believe-mazda-cx-7-locked-security-open.html

https://www.vehiclehistory.com/questions/how-do-i-perform-the-2007-mazda-cx-7-security-system-reset-204995

and more using the door lock and the key.

https://www.google.com/search?q=2007+mazda+cx-7+security+system+reset

..

Resetting the Passlock system should fix it. If it doesn't you need an auto electrician or an auto locksmith.

https://www.google.com/search?q=2001+gmc+yukon+security+system+reset

..

This is how you do a security system reset on an Impala. I hope you have the transponder receiver connected on the new column.

https://www.vehiclehistory.com/questions/how-do-i-perform-a-chevy-impala-security-reset-93585

Chevy Impala Won't Start Security Light - It Still Runs

https://itstillruns.com > chevy-wont-start-security-light-...
Make sure the security light is flashing. After 10 minutes the security light will stop flashing and either turn off or stay on steadily. When it does, then ...

How to reset anti theft system on a 2008 chevy impala - Fixya

https://www.fixya.com > ... > 2008 Chevrolet Impala
Sep. 1, 2019 - Turn ON the ignition, with the engine OFF. · Attempt to start the engine, then release the key to ON (vehicle will not start). · Observe the SECURITY light, after ..

..

fuel pump shut off due to security light on ????? Security systems do not disable fuel pumps , disables cranking and or fuel injectors . So what the service light isn't on ??? If the security light is lit codes are stored in the BCM - body control module ,theft deterrent module , What ever controls the theft system on your fantom vehicle . Your best bet ,have it towed to a qualified repair shop.

The security ( anti-theft ) system on that vehicle will not cause a no crank , depending on what you think a no crank is . Turning the key to start an nothing happens is a no crank - no start condition . Now if you turn the key to start an the starter engauges an spins the engine over but won't start an run ,this is a crank no start condition . Two different type problems all together . How did you reset system ? Disconnect the battery ?

Security system is tripped. Dealer will have to reset it.

It flashes due to a problem i the systems sensors. You must have the dealer scan the system to see what the faulty area is that is causing the light to flash indicating a fault.

If the security system is acting up, and you had to try th 10 minute reset, this means that some part is failing. The system rarely gets confused, its normally a failing part. The 10 minute reset can get you by for a while, but eventually the bad part will fail entirely and leave you stranded. This link might help you out.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

The security system (VATS/PassKey) is having problems, it's typical on those cars. You can find a great write-up here: http://newrockies.ca , it was the only thing that saved my Park Avenue.

It is theft detected. definitely security system. take to dealer or call dealer for code to reset.