-
Expert
93 Answers
- Posted on Jun 02, 2009
Re: need to replace broke window on 93 ford tempo.Pass....
Door Glass, Front
Removal
- Remove door trim panel and watershield. Refer to Section 01-05.
CAUTION: Prior to removing center pins from the rivet, it is recommended that a suitable block support be inserted between door outer panel and glass bracket to stabilize glass during rivet removal. Remove center pin from each rivet with a drift punch. Using a 1/4-inch diameter drill, drill out remaining rivets as damage to plastic glass retainer and spacer could result.
- Remove two rivets attaching glass to run and bracket assembly.
- Remove glass.
- Remove drillings and pins from bottom of door.
Installation
- Snap plastic retainer and spacer into two glass retainer holes. Make certain that metal washer in the retainer assembly is on outboard side of glass.
- Insert glass into door.
- Position glass to glass bracket. Install two rivets to secure glass to glass bracket.
NOTE: Two 1/4-inch-20 x 1-inch bolts and two 1/4-inch-20 nut and washer assemblies may be used as alternates for glass retention. However, torque must not exceed 4-7 Nm (36-61 lb-in). Equivalent metric retainers (6mm) may be used.
- Install door trim panel and watershield. Refer to Section 01-05.
2-Door Vehicles
4-Door Vehicles
×