My 2005 bmw x5 went out after replacing a light bulb. when done there was a message display on dashboard engine fail safe pro. what could it be?
SOURCE: 2003 BMW X5 radio display lights
BMW has a free fix for that! It's a factory recall with the pixels. Check with your dealer.
SOURCE: BMW X5 - 2005
Hi kuldipdhanja this sounds like it could be an internal fault with the video module or the sat nav drive, you could try discontecting the battery negative lead for 15 minutes to reset the control units, you will have to remove the spare wheel and unfasten the air compressor bracket to get to the battery, this fix may only be temporary but it is alot cheaper than replacing parts. regards mark.
SOURCE: BMW X5 Trans Fail Safe Program,
sometimes it will clear if you turn the X5 off and restart it. however, it could be an early indication that the tranny is about to expire. i have had it happen and it cleared with a power cycle, but also had friends where it cleared for a few weeks/months and returned. this time it was really the transmission that went bad. if you can't get it to clear, then i'd suggest taking it to the dealer and have them plug into it to have a better look.
SOURCE: Fog light replacement 2005 BMW X5
This link decribes how to change the Fog Lamp at Xoutpost.com. ( It is a forum for the X BMW's ). Good luck.
SOURCE: BMW X5 Trans Fail Safe Program,
IT'S VERY EASY TO RESET THE TRANSMISION'S COMPUTER. HOLD GAS PEDAL DOWN. TURN THE KEY TO THE NUMBER TWO. CONTINUE TO HOLD THE GAS PEDAL DOWN FOR THIRTY SECONDS.RELEASE THE GAS PEDAL AND PRESS THE BRAKE PEDAL FOR TEN SECONDS. NOW YOU CAN TURN THE VEHICLE ON. THAT SHOULD TAKE IT OUT OF SAFE MODE
592 views
Usually answered in minutes!
×