SOURCE: what is the firing order for an 89 gmc s15 2.8
Hello cman0906: My name is Roger and I will answer your question. The fire order is 1 5 6 4 3 2. See picture. Please rate the answer you recieved. This way we know your answer was correct. Should you need further halp please just ask. Thank You for using Fix Ya. Roger
SOURCE: firing order for a 1986 gmc s15
FIRING ORDERS
To avoid confusion, ALWAYS replace spark plug wires one at a time.
The most important thing to remember about the removal and
installation of a distributor, cap or spark plug cable is that all
wires MUST be labelled before they are disconnected. Keep in mind that
these figures depict a firing order where the distributor cap terminals
are relative to EACH OTHER only and they do not necessarily depict the
tower positions in relation to the rest of the engine. This is true
because any distributor which has been removed and reinstalled may have
been installed with the No. 1 spark plug tower at any position (360
degrees) in relation to the rest of the motor, as long as the rotor
aligned to the No. 1 tower when the No. 1 cylinder was at TDC of the
compression stroke (valves closed, ready for the plug to fire). As long
as the remaining wires were connected in the correct firing order
sequence (depending on direction of distributor rotation) the engine
will run. DO NOT EVER remove more than one wire from the distributor
cap at a time unless you tag ALL wires and towers to assure proper
installation.
Fig. 1: 1.9L engine . Firing order: 1-3-4-2 . Distributor rotation: counterclockwise
Fig. 2: 2.0L engine . Firing order: 1-3-4-2 . Distributor rotation: clockwise
Fig. 3: 2.5L engine . Firing order: 1-3-4-2 . Distributor rotation: clockwise
Fig. 4: 2.8L engine . Firing order: 1-2-3-4-5-6 . Distributor rotation: clockwise
Fig. 5: 4.3L engine. Firing order: 1-6-5-4-3-2 . Distributor rotation: clockwise
I hope help you with this (remember rated this help) Good luck.
SOURCE: looking for diagram of the fuse box for a 1984 gmc
dont realy need aq digram, open fuse box check each fuse with a test lamp when you get to the one that does not vlighht up chan ge it. berrydalewolf
SOURCE: replace u joint on GMC S15 pickup
You'll need a bench vice for this. A few sockets help as well. Once you get the shaft off the truck, put a smaller diameter socket on one side and a much larger diameter socket on the other and sandwich in a vice. Compress vice to drive the U-Joint through shaft (smaller socket will drive the one side through the other with the much larger socket). Installation is the reverse of removal.
SOURCE: I need manual for 1987
the best thing for you to do is stop by your local library and get your hands on a Haynes auto repair manual for your truck wish you the best of luck Michigan Man.also like to give you this information if you every have any hard to find GM-parts its Schram auto & truck parts they only sells GM- parts 1-800-292-1032 and they website is www.schramauto.com
74 views
Usually answered in minutes!
×