SOURCE: 1990 GMC Sierra 4x4 1500
the connections near the front axle that activate the motor to engage the system aren't melted? That's a comon problem for that body style. If there good, sounds like it could be that motor itself. To figure out if it's you motor or transfercase, jack up the rear end, have a friend inside shift into 4 wheel drive, or try to, and put it in gear and apply some gas. If the front driveshaft is turning then it's something with the front end. If not, farther back in the system.
SOURCE: chevy s10 4 wheel drive will not engage
There is a vaccuum operated switch located on the transfer case that sends vaccum to the accuator that pulls a cable that locks the front end in. Check for vac coming in and out of this switch if no vac out replace it. This switch is a very common problem. You can find them at most parts stores in the help section #49315. please rate.
SOURCE: Chevy pickup 4-wheel drive won't engage
Replace the push button selector assembly. Common failures. If that isnt the problem then the encoder motor on transfer case has failed. Try switch first.
SOURCE: 4 Wheel Drive Problem
Put the key in the run position and turn your 4wd on and off to listen for the electronic acuator to engage and disengage. If your can hear it then it's macanical and a Quick fix. On top of the transfercase on the driver's side, your going to find three vacuume tube connected to a cauume switch that may have gone bad. There common to go bad and there not the bad of a price at the Auto Zone. Check for any cracks on the vacuume line first then get your hands dirty. Good luck and keep an extra switch in your glove box.
SOURCE: 1992 chevy k2500 4 wheel drive not engaging
I have a 19934x4 bought it with 4 wheel drive notworking. indicator lights for 4x4 would notlight up but transfer seemed to be shiftin ok. frontaxel woul ot ingauge. I repled the front axel actuator an works fine now no problem. actuator is on the passenger sid back of the front axel pigand has a plug, mine was 2 wireroundpin plug but some have a flat pin 4 wire plug. 70 dollars at NAPA. wasa realy simple replacement didnt even need to jack up the truck. the actuator h a pin that electronically puses out engauging te front axel. a easy test is to put the truck in 4 wheel high. holdthe brak and givei little gas ad havesomeoneelse stand to the side ofthe front of the truck and see if the front axel spins. ifso th actutor is te most likely prblem. hope this helps.
Testimonial: "Ended up being the Actuator. Like you said easy fix and works great. THANK YOU"
231 views
Usually answered in minutes!
×