Question about 1997 Mitsubishi Galant

1 Answer

My car will not start

One week ago it start giving trouble to start only when i put gas direct into the combustion chamber i change the pump on top the head now it"s not starting .will tum-bull till the battery die it turn over like it want to start but it not what can i try again

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 101 Answers

Did you replace the fuel pressure regulator?
More Information for STANDARD MOTOR PRODUCTS PR186 Hard starting can be caused by a failing pressure regulator, and being able to start the car by putting fuel into the intake would be an indicator that you have a fuel delivery problem.

Posted on Jan 13, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Brian032472
  • 150 Answers

SOURCE: engine turns but won't start

No.: TSB-07-11-001
DATE: January, 2007
MODEL: 2002-07 Lancer 2.0L
SUBJECT:
HARD TO START ENGINE DTC P0340 (and P0335)

PURPOSE
The engine may be hard or impossible to start and MFI DTC P0335 and possibly P0340 may be stored due to abnormal wear to the camshaft position sensor support. Oil grooves have been added to the camshaft position sensor support to improve lubrication

Posted on Nov 04, 2008

emissionwiz
  • 85178 Answers

SOURCE: 98 galant motor stalls - dies when gas is pressed

I would take a look at possiable damage to the PCM (powertrain control module)

Posted on Nov 19, 2008

Molson02536
  • 3854 Answers

SOURCE: Where is the fuse & relay switch for the fuel pump located.

Locate the fuse box. Facing the engine, the box is located on the the right fender. The fuel pump fuse should be labeled, The fuel pump relay is Incorporated in the FI relay located under right center of dash. It is a metal relay usually bolted to the floor near the ecm. Good luck and hope this helps but first replace the the fuel filter since it's the easiest thing to do.

Posted on Jul 11, 2009

ftw1952
  • 10319 Answers

SOURCE: where is the fuel pump relay at on my 2002

relay is the problem if it dies in seconds after starting. Mitsubishi will show you exactly were it is if no body else does. Sorry I do not work on this model although all cars have a fuel pump relay and operates the same way

Posted on Sep 03, 2010

  • 5 Answers

SOURCE: I have a 95 eclipse

if u did all that and u still can hear the fuel pump run then u need to replace the fuel pump

Posted on Jan 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel injectors not firing on my 1995 oldsmobil cutlais ciera


Might be air in the fuel system. Did you bleed it out?

Feb 12, 2014 | 1995 Oldsmobile Cutlass Ciera

1 Answer

Car not starting


pressure guage should stay after you turn-off the ignition switch. check also if your engine has a cold start injector. it may be restricted.

Jan 13, 2014 | 1997 Mitsubishi Galant

2 Answers

White smoke coming through both ends of the car. oil changed 2 months ago. gas full. new battery. not sure whats wrong. having to put antifreeze in alot this past week. whats wrong??


the cylinder head gasket is failing- antifreeze is being sucked into combustion chamber and burning-thus the white smoke- sorry- you need to have heads planned and new head gaskets installed- cheers Denny

Dec 12, 2013 | 1992 Lexus Es 300

2 Answers

I ran my 2006 chevy uplander out of gas now it wont start even using starter fluid


after putting some gas in your tank, step on the gas pedal repeatedly (step to it fully), then while pressing, start your car. the fuel was completely drained from your system thus there are no fuel to burn in able for your car to start.

pressing the gas pedal repeatedly (around 10 times will do) will put some fuel in your combustion chamber, so the car will now have something to burn if you will start the car

Aug 05, 2011 | 2006 Chevrolet Uplander

1 Answer

I recently put in 1 gallon of diesel fuel in my car when it was almost empty and then later had an accident and car . slid in ditch but no impact. Yesterday it started after putting alittle gas in but...


Let me understand; put diesel fuel in a car designed for gasoline? If so your looking at a whirl of other issues. Diesel fuel is not as combustable as gasoline and requires much more compression (almost double) then a gasoline vehicle, also diesel fuel is more oily and will gel up in cold temps which is why there is a heater on the motor to warm the fuel before entering the combustion chamber and third the engine needs to be pre warmed (glow plugs) to help ignite the diesel fuel. I would start by flushing the engines fuel system/tank and hopefully the injectors/fuel pump werent damaged/clogged. Its prob smoking because the fuel isnt igniting 100% and its like burning oil, it doesn't combust/explode like gasoline it just burns black due to incomplete combustion.

May 03, 2011 | 2007 Fiat X1/9

1 Answer

Hi John here PA, I have a 1997 BMW 740il with overheating problems, about 3-4 months ago I blew a upper radiator hose, until then, except for topping off the coolant level every so often everything was...


Best test,,NAPA sells a combustion leak tester(balkamp #700-1006) A tube of liquid that will change color if combustion gas is in the cooling system.Thinking you may be right about a head gasket problem or possibly a crack in the head.
It comes with instructions and is cheaper than having a shop guess at the trouble.

Apr 18, 2011 | 1997 BMW 7 Series

1 Answer

My car burns oil and gives a smell off whenever i drive it long enough for it to warm up i had to change the oil because the level was really low so i put high mileage oil. it has 80000 miles on it. i put...


It sounds like oil is getting past the rings. you can check the compression on each cylinder to see what one it is, or pull the spark plugs out and check each one you should be able to tell if oil is getting in the combustion chamber. If it is just the rings it wont be cheap to fix but the sooner the better.

Nov 11, 2010 | 2004 Pontiac Grand Prix

1 Answer

Check engine light stays on. changed oxygen sensor, pcv valve, coolant sensor, switched out PROM chip, and cannot get a code to blink. replaced all hoses coming off carb. smog pump and egr valve been...


what you could start with is checking to see what trouble codes are being logged for this vehicle...if the engine light stays on, it means the ecu is registering a fault......by the means of a trouble code...now the trouble code doesnt tell you how to fix it, but it does give you the direction to go down...judst wondering if you have tried to obtain the trouble codes

Aug 26, 2010 | 1981 Chevrolet Corvette

1 Answer

02 jetta 1.8t Epc trouble shifting, wont start


Need the right software to diagnose the fault ,,,,sorry best advice here is dealer only

Sep 08, 2009 | Volkswagen Jetta Cars & Trucks

Not finding what you are looking for?
1997 Mitsubishi Galant Logo

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...