How do you get the back spark plugs on a 2004 Sebring Convertible
SOURCE: Spark plug location on sebring convertible
Depending on the tightness of the socket fit and the engine, carefully pull the spark plug out of the bore
Hope this helps some...best that I can find!
SOURCE: Is it difficult to change the spark plugs on a
Yes. Yopu must remove the plenum, which means a new gasket.
The plug wires go down into the valve covers. The circular gaskets there often leak, so I would replace the wires and gaskets around them at the same time because it is all exposed.
SOURCE: 1999 Chrysler Sebring Convertible code P1495. I
Code 1495 = Leak Detection Pump Solenoid Circuit
Remove the connector from the solenoid (should be on the back wall,
just to the drivers side of the air-hat). You will have the solenoid
to check and the harness. What you want to measure is the voltage
coming from the harness and the resistance of the solenoid.
Turn the
key to the "ON" position but do not start the motor; the voltage at
the connector should be at least 10V or more,.now, check the
resistance of the solenoid (should be around 35 ohms).
Hope helps.
348 views
Usually answered in minutes!
×