2002 concord abs-brake airbag light stay on untill bang steering
Any clue as to why my abs-brake and air bag lights stay on when car is running and i lose power to windows and heater fan and then when i bang hard on steering wheel they go out and power comes back on
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the air bag for your Dodge did not become standard until 1998 you should not have one if the light is on something is fussed together if it runs right cover the light warning and go Good Luck Mike L.
Disconnect the battery before attempting any airbag repairs.
Remove the steering wheel connectors and check they are all clean and reconnect them. Reassemble the steering wheel and horn press assembly then take it to a Toyota service centre or a garage with a Toyota scanner and get the system reset.
you need to get in touch with toyota they had a recall on your vehicle due to airbag.THE STEERING COLUMN ASSEMBLY CONTAINS ELECTRICAL CONNECTIONS TO THE DRIVER'S AIRBAG MODULE HOUSED IN A SPIRAL CABLE ASSEMBLY, WHICH INCLUDES A FLEXIBLE FLAT CABLE (FFC). DUE TO THE SHAPE AND LOCATION OF THE FFC'S RETAINER, THE FFC COULD BECOME DAMAGED WHEN THE STEERING WHEEL IS TURNED.
Consequence: IF THE FFC IS DAMAGED, CONNECTIVITY TO THE DRIVER'S AIR BAG MODULE COULD BE LOST AND THE AIR BAG DEACTIVATED. THE FAILURE OF THE DRIVER'S AIR BAG TO DEPLOY IN THE EVENT OF A CRASH THAT TYPICALLY NECESSITATES DEPLOYMENT INCREASES THE RISK OF INJURY TO THE DRIVER.
https://answers.yahoo.com/question/index?qid... Jul 12, 2014 - My battery light stays on sometimes it might blink on and off. But the problem is i can be driving my car and my airbag light and abs light will ...
www.civinfo.com > ... > Bugs, faults and irritations Feb 12, 2012 - 18 posts - 5 authors
Airbag light. ABS ALSO - the speedometer, rev counter and engine temp ... 30 mins driving (apart from engine management light which stays on). ... I have ruled out problems with the alternator and the relays - they're all fine.
? 4:14 www.youtube.com/watch?v=tIBjIr9a42w Feb 6, 2010 - Uploaded by vehix411
airbag abs srs light diagnose without a scanner air bag ... Alsowhen I tried the scan plugging the paper ...
If the Airbag light is on, it indicates that a electronic fault is stored in the memory for the airbag. You will need to have a diagnostic check done to pinpoint what the fault is, have it sorted out and only then can the fault be cleared so the light will go off. The ABS light also indicates a fault on the electronic side of the braking system. If the light comes on as you start the vehicle this indicates that there is an open circuit in the wiring or that the ABS control unit itself is faulty. If the light only comes on once the vehicle is in motion, this indicates that a wheel speed sender is incorrectly fitted or dirty and not sensing the ABS Rotor on one of the wheels. If a CV joint has been replaced, the joint may not have an ABS ring fitted on it.[front] At the rear the ABS pick up is fitted on the inside of the brake discs and must be fitted to the new disc when replacing discs.
When the airbag light is on it means a fault has occurred in the system and the airbag diagnostic monitor has disabled the system, the most common problem that turns the light on is a break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the diagnostic monitor, the part is called th clock spring contact, a coiled up ribbon electrical contact that turns with the wheel
Someone or something heavy was on the Passenger seat. The wire harness under that seat has become loose or disconnected. Completely unplug and clean treminals and reconnect. SOLVED
×