I am having engine management problems due to crankshaft sensor. The motor ticking is lumpy with loss of power and the rev counter stops working. Can you tell me where the location of the crankshaft sensor is so I can fix it Thanks
Wheres the computer on this vehicle fitted is it bolted to the inlet manifold by any chance? the sensor should be front right side level with the crankshaft ,not on the bell housing
SOURCE: location of crank sensor on renault megane 1.6, 2004
bit confused...the cranksensor will be on the gearbox housing the camsensor will be near the cams not the gearbox if the camsensor has packed up it wont start but if it packs up while driving the engine will run untill you stop it then it wont start,a cranksensor could cause the engine to stop at anytime if it fails..your problem could be the idle air control valve or a timing related issue..
SOURCE: Crankshaft sensor location
on the block close to the sump and flywheel on the front side of the engine it may differ on other engines above is for X18XE
SOURCE: toyota hiace GS300 d4d diesel 2053 engine stops whilst ideling
you have a leak in one of your fuel lines . but its not be a outward leak its sucking air .first look at all of the steel lines. if no problem found go to all the rubber lines you are sure to find the problem
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
130 views
Usually answered in minutes!
×