P0340 p0325 sensor camshaft distributor - 1999 Nissan Altima

Please understand the fault code you have, it doesn't mean the sensor is defective, many other factors cause this code. Go to the link please. P0340 Nissan Camshaft Position Sensor Circuit Bank 1

P0340- Camshaft Pos Sensor Circ Error (bank1/1Sensor) Here is your code results and no the sensor is not in the distributor. Looks like the #1 senor is bad.

you need a proper scan tool and do a crankshaft camshaft corellation allignment.

P0340 Camshaft Position Sensor Circuit Malfunction Full list of the OBD2 DTC from P0300 to P0399

P0325 Knock Sensor 1 Circuit (Bank 1 or Single Sensor) -Circuit Malfunction
P0326 Knock Sensor 1 Circuit Range/Performance (Bank 1 or Single Sensor)
P0327 Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor)
P0328 Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor)
P0329 Knock Sensor 1 Circuit Input Intermittent (Bank 1 or Single Sensor)
P0330 Knock Sensor 2 Circuit (Bank 2) -Circuit Malfunction
P0331 Knock Sensor 2 Circuit Range/Performance (Bank 2)
P0332 Knock Sensor 2 Circuit Low Input (Bank 2)
P0333 Knock Sensor 2 Circuit High Input (Bank 2)
P0334 Knock Sensor 2 Circuit Input Intermittent (Bank 2)
P0335 Crankshaft Position Sensor -Circuit Malfunction
P0336 Crankshaft Position Sensor -Range/Performance
P0337 Crankshaft Position Sensor -Low Input
P0338 Crankshaft Position Sensor -High Input
P0339 Crankshaft Position Sensor -Intermittent
P0340 Camshaft Position Sensor A Circuit (Bank 1 or Single Sensor) -Circuit Malfunction
sorry would a play with this to know for sure ,check the wiring plugs onto the sensors to make sure their not full of oil or corroded

The camshaft position sensor is located on the distributor for all engines designed for the 1998 Dodge Dakota. Accessing the sensor requires removing the distributor cap and the distributor rotor. The camshaft sensor pigtail comes through the front of the distributor and connects to the engine wiring harness above the intake manifold.

I would say that the P0340 is causing your no start problem.....This is a cam sensor code......The cam sensor is in the distributor and is not servicable.....I would recommend taking it to a repair shop to properly diagnose the problem before replacing the distributor.

P0340 is for camshaft position sensor circuit malfunction so the problem can be in you hav already changed sensor, then you need to check wiring from sensor to ecu and if the wires are ok than check the ecu! It can be either of them cousing the problem.

CAMSHAFT SENSOR BUILT IN THE DISTRIBUTOR.

P0340....Camshaft Position Sensor 'A' Circuit (Bank 1 or Single Sensor)
P0325....Knock Sensor 1 Circuit (Bank 1 or Single Sensor)if you have no spark it your cam sensor