Cant locate fuel pump relay for my 97 elantra. car cranks but wont start. getting fuel to rail, checked pressure regulator, power at injectors, checked cam sensor and crank sensor, replaced fuel pump and filter.
SOURCE: 1994 pontiac bonneville fires up but stalls imediatly
WOW a 94 with 46K on it thats rare. Your computer may be bad it sends the pulse to the injector.
SOURCE: 1998 Lincoln Town Car cranks but does not start.
possible just not probable. you need to see if there is any pressure to fuel rail. if not youre going to have to by pass the fuel pump and see if it is getting voltage. if so then apply a seperate voltage and ground wire to the pump to see if it kicks on. come to think of it, it could be the PATS system(security) that shuts down the system. it will crank but will not fire. your ford dealer will need to reprogram the system.
SOURCE: car cranks but wont start i replaced cam,crank
looking for my fuel pump on a 2000 lincoln navagator
SOURCE: Engine cranks over but no
regarding the fan speed for heather motor replace the relay under the glove compartment remove the cover and replace it easy to do.
Fuel Pressure Regulator is located on the fuel rail.
1. Disconnect the negative battery cable.
2. Properly relieve the fuel system pressure.
3. Remove the air cleaner outlet tube(s).
4. Remove any necessary components to access the pressure regulator.
5. Disconnect the vacuum hose from the pressure regulator.
6. Remove the pressure regulator attaching screws.
7. Remove the pressure regulator from the fuel rail.
To Install
8. Discard the O-rings on the pressure regulator and replace them with new ones.
9. Lubricate the O-rings with clean engine oil.
10. Install the regulator into the fuel rail and tighten the retaining screws.
11. Connect the vacuum hose to the regulator.
12. Install any components removed to access the regulator.
13. Install the air cleaner outlet tube(s).
711 views
Usually answered in minutes!
×