Question about 1995 Geo Tracker

1 Answer

Don't know where the fuse is located for the 4 wheel drive actuator on a 2004 Tracker!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Geo Master
  • 20,706 Answers

2004. chevy tracker
yes, i have the FULL FSM.
actuator , you mean the front axle pump?
there is non, err, not directly
the PCM drives the pump direct, Page 9-a19(FSM)
pinsc51-2 pin 15, drives and pin 18 the PCM senses if it did.?
the pump is grounded, the PCM drives it on
the PCM has many rules for , not activating 4wd.
speed, load.,.RPM, etc.
and the switch is not on. C51-2,pin 11 is pcm 4wd switch input
and goes to 12v, for 4wd demand, then the PCM glow the lamp
and maybe turns on the pump.
post symptoms for better help.

Posted on Jan 05, 2014

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: four wheel drive will not work on 1995 geo tracker

You need to take the cover off your hub and clean and grease the lock ring. It is attached to the spring. It sounds as though your hub is rusted open.

Posted on Mar 09, 2009

HansPP
  • 2510 Answers

SOURCE: 1997 geo tracker with manual

Strip the hubs, inspect the drive dogs and relubricate with new grease. If there are signs of obvious wear then parts will need to be replaced as required.

Posted on Jan 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 GMC suburban actuator and fuse location. There is not one on front differential and no place for fuse in fuse block. 4 wheel will not engage. No owners manual


The actuator will not be on the front differential or drive line, it will be on the transfer case, which is mounted behind the transmission. Follow the front drive shaft back from the front differential, and the component at the rear of the driveshaft is the transfer case. That is where four wheel drive is engaged/disengaged.
I'm not familiar with your vehicle, but if you have a separate lever to engage 4wd, there will not be a fuse for the actuator - it is a manual system. If the 4wd is selected electrically, check that all wiring and connectors on the transfer case are in good condition.

Sep 25, 2016 | 1990 GMC Suburban

1 Answer

Service 4 wheel drive message comes on and no lights for 2and 4 wheel drive come on. On my 2004 gmc


Often lights under a dash or indicators just blow out bulbs. If more than one thing isn't lighting and are centralized check fuses to see if its blown. Bulb or fuse. IMHO. MIGHT be a sensor on tranny too. Hope not.

Here's a video with detaile dinstrauctions and other people's fuse questions. New fuses?

Kind Regards,
Scott

Interior Fuse Box Location 1999 2007 GMC Sierra 2500 HD 2004 GMC Sierra...

Amazon com Fuses Fuses Accessories Automotive

2004 GMC Sierra fuse box Questions

Kind Regards,

Scott

Feb 11, 2015 | 2004 GMC Sierra

2 Answers

My 4 wheel drive is not working on my 2003 tracker zr2


2001 Chevy Tracker 6 cyl Four Wheel Driveicon1.png Automatic

My 4 wheel drive stop working on my 2001 ZR2 chevrolet Tracker. It has a shifter on the floor and when it is put into 4 hi or 4 lo. the vehicleicon1.png does not change from two wheel drive into 4. The 4x4icon1.png Dash light indicator stop coming on. What should I check?
I lost 4x4 traction when drivinglb_icon1.png in icy conditions.

4-wheel-drive-not-working-sd252lpxxblxu5oo54bbyxxi-3-5.jpg

Dec 31, 2011 | 2003 Chevrolet Tracker

1 Answer

I have a 2004 chevy trail blazer ext 4 wheel drive does not work used it last week and was fine


When you switch from 2HI to 4HI, you should hear two distinctive sounds from under the truck, one is the transfer case actuator and the other is the front differential actuator. If you hear both and you still do not have power going to the front wheels, then there is a problem with the front disconnect assembly.

Oct 30, 2011 | 2004 Chevrolet TrailBlazer

2 Answers

Where is the fuse box ( interior ) 2003 4/dr Chevy Tracker


daughter drove tracker 50 miles to lake cabin and car stalled as she came into driveway, car turns over but no fireing could this be electronic fuel pump or what fuse or what?

Aug 03, 2011 | 2003 Chevrolet Tracker

1 Answer

My 4 wheel drive switch would engage my 4+4 wi


If the transfer case is engaging, try it in 4X4 low foot on the brake and other on the gas (power braking) and you can get the rear tires to break loose your 4 wheel drive actuator switch is bad, a common problem on these 4X4's. It is a simple repair and is located on the front differential.

Feb 03, 2010 | 1997 GMC Yukon

4 Answers

Four-wheel drive will not work and is not transfer case, could be a fuse?


IT COULD BE A FUSE THERE ARE FUSES UNDER THE HOOD FOR 4 WHEEL DRIVE ALSO IF THAT DOED NOT WORK CHECK 4 WHEEL DRIVE SELINOID

Dec 13, 2009 | 2002 Chevrolet TrailBlazer

2 Answers

My 2000 chevy tracker will not shift into 4 wheel drive?


How Fast Where You Going? You Know You Have To Be At A Stop To Enable The 4wd? If You Weren't You May Have Destroyed It

Jan 05, 2009 | 2000 Chevrolet Tracker

Not finding what you are looking for?
1995 Geo Tracker Logo

586 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...