Question about 1995 Jeep Grand Cherokee
I've got a jeep grand cherokee 1995 limited and we just got a jeep grand cherokee 1995 limited v8 which the transmission is slipping. Can I put the transmission from the straight 6 into the v8 jeep?
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)
Posted on Feb 19, 2010
Depending on how many miles you have on it. You may need to have some repairs done. I don't know if there is much you can do to a jeep after it starts slipping other than try and change the fluid. The rebuild is the best option for you for sure. But you could put some no slip transmission fluid additives in it. Go to a parts store if you think thats your best option and tell them whats wrong and they will hook you up with some good additives. Go to Advance Auto or Auto Zone. The rebuild will be less expensive if the transmission still functions. Around $1000 versus the non functioning transmission that would cost about $1400-$2000. New transmission cost a lot more.
And don't forget! Please leave four thumbs up. I always try my best at explaining my answer to your problem.
And for your safety, here is a complete list of recalls on your vehicle. If your vehicle is affected by one or more of these recalls, then you may qualify for a free repair!
Posted on Jun 28, 2010
Assume since you say filter it is automatic.
Before starting the job obtain the fluid and filter for your vehicle. The parts store can provide you the right kind and amount of fluid based on Make Year Model. Also obtain new gasket.
Transmission must be cool.
Raise vehicle on jack stands.
Locate the fluid pan. Remove the side and front bolts.
Place a drain pan under the transmission capable of holding 8 quarts (two gallons).
Loosen the rear pan mounting bolts. Fluid should start to drain around the pan at the front. If not the pan is stuck. Pry it gently at the front with a flexible putty knife.
Once fluid is draining you can eventually take the rear bolts all the way out and pour off the balance of fluid.
Clean the gasket mounting surface on the transmission.
Clean the fluid pan completely.
Remove the old filter. It will be held with screws (bolts).
Install new filter.
Assure surfaces are still clean. Put new gasket in place, and install pan, tightening the bolts (screws) gradually until correct torque for your transmission is reached.
Take car off jack stands.
Add the correct amount of fluid for your vehicle through the filler tube. (Parts store can look this up when you are there).
Start with engine in park. Maintain idle, don't race engine.
Shift to each range setting, and then back to neutral.
Watch for leaks - if occur will need to repeat the procedure but the filter can be left in place.
Posted on Sep 07, 2010
Tips for a great answer:
Oct 01, 2014 | 1995 Jeep Grand Cherokee
Mar 30, 2012 | 1993 Jeep Grand Cherokee
Feb 01, 2011 | 2001 Jeep Grand Cherokee
May 21, 2010 | 1995 Jeep Grand Cherokee
Apr 15, 2010 | 1995 Jeep Grand Cherokee
Aug 23, 2009 | 1994 Jeep Grand Cherokee
Dec 31, 2008 | 1994 Jeep Grand Cherokee
Dec 05, 2008 | 1993 Jeep Grand Cherokee
May 25, 2017 | 1995 Jeep Grand Cherokee
532 people viewed this question
Usually answered in minutes!